Pin configuration property "input-enable" was used with the intention to
disable the output, but this is done by default by Linux drivers. Since
patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not
input-enable") the property is not accepted anymore.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Link: https://lore.kernel.org/r/20230410181005.25853-3-krzysztof.kozlowski@linaro.org
pins = "gpio73";
function = "gpio";
bias-disable;
- input-enable;
};
touch_pin: touch-state {
drive-strength = <2>;
bias-disable;
- input-enable;
};
reset-pins {
function = "gpio";
drive-strength = <2>;
bias-disable;
- input-enable;
};
sdc1_on: sdc1-on-state {
function = "gpio";
drive-strength = <2>;
bias-disable;
- input-enable;
};
reset-pins {
pins = "gpio75";
function = "gpio";
drive-strength = <16>;
- input-enable;
};
devwake-pins {
i2c_touchkey_pins: i2c-touchkey-state {
pins = "gpio95", "gpio96";
function = "gpio";
- input-enable;
bias-pull-up;
};
i2c_led_gpioex_pins: i2c-led-gpioex-state {
pins = "gpio120", "gpio121";
function = "gpio";
- input-enable;
bias-pull-down;
};
wifi_pin: wifi-state {
pins = "gpio92";
function = "gpio";
- input-enable;
bias-pull-down;
};
function = "gpio";
drive-strength = <2>;
bias-disable;
- input-enable;
};
bt_host_wake_pin: bt-host-wake-state {