From: Lukasz Majewski Date: Fri, 29 Mar 2024 11:18:07 +0000 (+0100) Subject: arm: spl: Add definition for PHY reset GPIO for XEA HW rev. 2 X-Git-Url: http://git.dujemihanovic.xyz/posts?a=commitdiff_plain;h=3603e64003c3743fa5bc4dbf2a50f898e972ba01;p=u-boot.git arm: spl: Add definition for PHY reset GPIO for XEA HW rev. 2 The imx287 based XEA board's revision 2 uses GPIO_3_21 for PHY reset It is safe to keep the GPIO_2_13 as well, as in the SPL SPI1 is not used for transmission. This simplifies the code, as the proper configuration is performed either in falcon boot's read DTB or in u-boot proper (with correct FIT configuration chosen). Signed-off-by: Lukasz Majewski --- diff --git a/board/liebherr/xea/spl_xea.c b/board/liebherr/xea/spl_xea.c index 551ed6fbae..4068a2ad49 100644 --- a/board/liebherr/xea/spl_xea.c +++ b/board/liebherr/xea/spl_xea.c @@ -225,7 +225,8 @@ const iomux_cfg_t iomux_setup[] = { MX28_PAD_ENET0_TXD0__ENET0_TXD0 | MUX_CONFIG_ENET, MX28_PAD_ENET0_TXD1__ENET0_TXD1 | MUX_CONFIG_ENET, MX28_PAD_ENET0_TXD3__ENET1_TXD1 | MUX_CONFIG_ENET, - MX28_PAD_SSP1_CMD__GPIO_2_13, /* PHY reset */ + MX28_PAD_SSP1_CMD__GPIO_2_13, /* PHY reset HW Rev. 1*/ + MX28_PAD_SAIF0_LRCLK__GPIO_3_21, /* PHY reset HW Rev. 2*/ /* TIVA boot control */ MX28_PAD_GPMI_RDY3__GPIO_0_23 | MUX_CONFIG_BOOT, /* TIVA0 */