From 8649995c76bb38b9cbfd94169e41ce80c0d5f6ac Mon Sep 17 00:00:00 2001 From: Andre Przywara Date: Tue, 26 Apr 2022 23:58:53 +0100 Subject: [PATCH] spi: sunxi: Add support for F1C100s SPI controller The SPI controllers in the Allwinner F1Cx00 series of SoCs are compatible to the H3 IP. The only difference in the integration is the missing mod clock in the F1C100, instead the SPI clock is directly derived from the AHB clock. We *should* be able to model this through the DT, but the addition of get_rate() requires quite some refactoring, so it's not really worth in this simple case: We programmed both the PLL_PERIPH to 600 MHz and the PLL/AHB divider to 3 in the SPL, so we know the SPI base clock is 200 MHz. Since we used a hard coded fixed clock rate of 24 MHz for all the other SoCs so far, we can as well do the same for the F1C100. Define the SPI input clock and maximum frequency differently when compiling for the F1C100 SoC. Also adjust the power-of-2 divider programming, because that uses a "minus one" encoding, compared to the other SoCs. This allows to enable SPI flash support for the F1C100 boards. Signed-off-by: Andre Przywara --- drivers/spi/spi-sunxi.c | 9 +++++++++ 1 file changed, 9 insertions(+) diff --git a/drivers/spi/spi-sunxi.c b/drivers/spi/spi-sunxi.c index 628294948b..c56d82d998 100644 --- a/drivers/spi/spi-sunxi.c +++ b/drivers/spi/spi-sunxi.c @@ -72,9 +72,15 @@ DECLARE_GLOBAL_DATA_PTR; #define SUN4I_XMIT_CNT(cnt) ((cnt) & SUN4I_MAX_XFER_SIZE) #define SUN4I_FIFO_STA_RF_CNT_BITS 0 +#ifdef CONFIG_MACH_SUNIV +/* the AHB clock, which we programmed to be 1/3 of PLL_PERIPH@600MHz */ +#define SUNXI_INPUT_CLOCK 200000000 /* 200 MHz */ +#define SUN4I_SPI_MAX_RATE (SUNXI_INPUT_CLOCK / 2) +#else /* the SPI mod clock, defaulting to be 1/1 of the HOSC@24MHz */ #define SUNXI_INPUT_CLOCK 24000000 /* 24 MHz */ #define SUN4I_SPI_MAX_RATE SUNXI_INPUT_CLOCK +#endif #define SUN4I_SPI_MIN_RATE 3000 #define SUN4I_SPI_DEFAULT_RATE 1000000 #define SUN4I_SPI_TIMEOUT_MS 1000 @@ -256,6 +262,9 @@ static void sun4i_spi_set_speed_mode(struct udevice *dev) reg |= SUN4I_CLK_CTL_CDR2(div) | SUN4I_CLK_CTL_DRS; } else { div = fls(div - 1); + /* The F1C100s encodes the divider as 2^(n+1) */ + if (IS_ENABLED(CONFIG_MACH_SUNIV)) + div--; reg &= ~((SUN4I_CLK_CTL_CDR1_MASK << 8) | SUN4I_CLK_CTL_DRS); reg |= SUN4I_CLK_CTL_CDR1(div); } -- 2.39.5