From 7a2704369c70ce3711dfa1a1ba795524899136a0 Mon Sep 17 00:00:00 2001 From: Masahiro Yamada Date: Fri, 17 Apr 2020 16:51:42 +0900 Subject: [PATCH] mtd: rawnand: denali: configure SPARE_AREA_SKIP_BYTES only for denali_spl This CONFIG option is only used in denali_spl.c Move it close to SPL_NAND_DENALI, and make it depend on SPL_NAND_DENALI. Signed-off-by: Masahiro Yamada --- drivers/mtd/nand/raw/Kconfig | 18 +++++++++--------- 1 file changed, 9 insertions(+), 9 deletions(-) diff --git a/drivers/mtd/nand/raw/Kconfig b/drivers/mtd/nand/raw/Kconfig index c4d9d31388..06b2ff972c 100644 --- a/drivers/mtd/nand/raw/Kconfig +++ b/drivers/mtd/nand/raw/Kconfig @@ -121,15 +121,6 @@ config NAND_DENALI_DT Enable the driver for NAND flash on platforms using a Denali NAND controller as a DT device. -config NAND_DENALI_SPARE_AREA_SKIP_BYTES - int "Number of bytes skipped in OOB area" - depends on NAND_DENALI - range 0 63 - help - This option specifies the number of bytes to skip from the beginning - of OOB area before last ECC sector data starts. This is potentially - used to preserve the bad block marker in the OOB area. - config NAND_LPC32XX_SLC bool "Support LPC32XX_SLC controller" help @@ -404,6 +395,15 @@ config SPL_NAND_DENALI This is a small implementation of the Denali NAND controller for use on SPL. +config NAND_DENALI_SPARE_AREA_SKIP_BYTES + int "Number of bytes skipped in OOB area" + depends on SPL_NAND_DENALI + range 0 63 + help + This option specifies the number of bytes to skip from the beginning + of OOB area before last ECC sector data starts. This is potentially + used to preserve the bad block marker in the OOB area. + config SPL_NAND_SIMPLE bool "Use simple SPL NAND driver" depends on !SPL_NAND_AM33XX_BCH -- 2.39.5