From 6beb43e0178a375b90a30b7790d794cafb1e64de Mon Sep 17 00:00:00 2001 From: Nishanth Menon Date: Fri, 25 Aug 2023 13:02:57 -0500 Subject: [PATCH] arm: mach-k3: am625_init: Use IS_ENABLED() Drop the #ifdeffery and use IS_ENABLED() inline check and let the compiler do it's thing. Reviewed-by: Tom Rini Reviewed-by: Mattijs Korpershoek Tested-by: Mattijs Korpershoek Signed-off-by: Nishanth Menon --- arch/arm/mach-k3/am625_init.c | 35 +++++++++++++++++------------------ 1 file changed, 17 insertions(+), 18 deletions(-) diff --git a/arch/arm/mach-k3/am625_init.c b/arch/arm/mach-k3/am625_init.c index 0e5d44269e..165bca6885 100644 --- a/arch/arm/mach-k3/am625_init.c +++ b/arch/arm/mach-k3/am625_init.c @@ -121,10 +121,10 @@ void board_init_f(ulong dummy) struct udevice *dev; int ret; -#if defined(CONFIG_CPU_V7R) - setup_k3_mpu_regions(); - rtc_erratumi2327_init(); -#endif + if (IS_ENABLED(CONFIG_CPU_V7R)) { + setup_k3_mpu_regions(); + rtc_erratumi2327_init(); + } /* * Cannot delay this further as there is a chance that @@ -156,29 +156,28 @@ void board_init_f(ulong dummy) preloader_console_init(); -#ifdef CONFIG_K3_EARLY_CONS /* * Allow establishing an early console as required for example when * doing a UART-based boot. Note that this console may not "survive" * through a SYSFW PM-init step and will need a re-init in some way * due to changing module clock frequencies. */ - early_console_init(); -#endif + if (IS_ENABLED(CONFIG_K3_EARLY_CONS)) + early_console_init(); -#if defined(CONFIG_K3_LOAD_SYSFW) /* * Configure and start up system controller firmware. Provide * the U-Boot console init function to the SYSFW post-PM configuration * callback hook, effectively switching on (or over) the console * output. */ - ret = is_rom_loaded_sysfw(&bootdata); - if (!ret) - panic("ROM has not loaded TIFS firmware\n"); + if (IS_ENABLED(CONFIG_K3_LOAD_SYSFW)) { + ret = is_rom_loaded_sysfw(&bootdata); + if (!ret) + panic("ROM has not loaded TIFS firmware\n"); - k3_sysfw_loader(true, NULL, NULL); -#endif + k3_sysfw_loader(true, NULL, NULL); + } /* * Force probe of clk_k3 driver here to ensure basic default clock @@ -209,11 +208,11 @@ void board_init_f(ulong dummy) enable_mcu_esm_reset(); } -#if defined(CONFIG_K3_AM64_DDRSS) - ret = uclass_get_device(UCLASS_RAM, 0, &dev); - if (ret) - panic("DRAM init failed: %d\n", ret); -#endif + if (IS_ENABLED(CONFIG_K3_AM64_DDRSS)) { + ret = uclass_get_device(UCLASS_RAM, 0, &dev); + if (ret) + panic("DRAM init failed: %d\n", ret); + } spl_enable_dcache(); } -- 2.39.5