From 144cb060831189ec0fb985bf66ec7a3156e3d7dd Mon Sep 17 00:00:00 2001 From: Andy Shevchenko Date: Wed, 27 Oct 2021 14:28:10 +0300 Subject: [PATCH] x86: edison: Don't take SD card detect pin into consideration There are two PCB designs in the wild which use the opposite signaling for SD card detection. This makes U-Boot working in one case and failing in the other. Quirk this out by disconnecting SD card detection pin from the PCB by switching it to mode 3. In the disconnected state the read value is always the same and inverted to what we are expecting in the code. BugLink: https://github.com/edison-fw/meta-intel-edison/issues/136 Signed-off-by: Andy Shevchenko Reviewed-by: Bin Meng --- arch/x86/dts/edison.dts | 17 +++++++++++++++++ 1 file changed, 17 insertions(+) diff --git a/arch/x86/dts/edison.dts b/arch/x86/dts/edison.dts index 2c8cf6c071..b3658b8c30 100644 --- a/arch/x86/dts/edison.dts +++ b/arch/x86/dts/edison.dts @@ -94,6 +94,12 @@ sdcard: mmc@ff3fa000 { compatible = "intel,sdhci-tangier"; reg = <0xff3fa000 0x1000>; + /* + * In the disconnected state of the SD Card Detection pin + * the read value is always the same and inverted to what + * we are expecting in the code. + */ + cd-inverted; }; pmu: power@ff00b000 { @@ -131,6 +137,17 @@ compatible = "intel,pinctrl-tangier"; reg = <0xff0c0000 0x8000>; + /* + * Disconnect SD card detection pin, so it won't affect + * the reality on two different PCB designs where it's + * using the opposite signaling: Edison/Arduino uses + * Active Low, while SparkFun went with Active High. + */ + sd_cd@0 { + pad-offset = <37>; + mode-func = <3>; + }; + /* * Initial configuration came from the firmware. * Which quite likely has been used in the phones, where I2C #8, -- 2.39.5