From: Simon Glass Date: Mon, 2 Aug 2021 00:54:34 +0000 (-0600) Subject: net: Drop DM_PCI check from designware driver X-Git-Url: http://git.dujemihanovic.xyz/login.html?a=commitdiff_plain;h=e882a59ef1b293b6af496c3bd8417f648315a42f;p=u-boot.git net: Drop DM_PCI check from designware driver We don't need this check anymore since when PCI is enabled, driver model is always used. Drop it. Signed-off-by: Simon Glass --- diff --git a/drivers/net/designware.c b/drivers/net/designware.c index 5d92257e74..5aaac603a0 100644 --- a/drivers/net/designware.c +++ b/drivers/net/designware.c @@ -756,16 +756,16 @@ int designware_eth_write_hwaddr(struct udevice *dev) static int designware_eth_bind(struct udevice *dev) { -#ifdef CONFIG_DM_PCI - static int num_cards; - char name[20]; - - /* Create a unique device name for PCI type devices */ - if (device_is_on_pci_bus(dev)) { - sprintf(name, "eth_designware#%u", num_cards++); - device_set_name(dev, name); + if (IS_ENABLED(CONFIG_PCI)) { + static int num_cards; + char name[20]; + + /* Create a unique device name for PCI type devices */ + if (device_is_on_pci_bus(dev)) { + sprintf(name, "eth_designware#%u", num_cards++); + device_set_name(dev, name); + } } -#endif return 0; } @@ -831,12 +831,11 @@ int designware_eth_probe(struct udevice *dev) else reset_deassert_bulk(&reset_bulk); -#ifdef CONFIG_DM_PCI /* * If we are on PCI bus, either directly attached to a PCI root port, * or via a PCI bridge, fill in plat before we probe the hardware. */ - if (device_is_on_pci_bus(dev)) { + if (IS_ENABLED(CONFIG_PCI) && device_is_on_pci_bus(dev)) { dm_pci_read_config32(dev, PCI_BASE_ADDRESS_0, &iobase); iobase &= PCI_BASE_ADDRESS_MEM_MASK; iobase = dm_pci_mem_to_phys(dev, iobase); @@ -844,7 +843,6 @@ int designware_eth_probe(struct udevice *dev) pdata->iobase = iobase; pdata->phy_interface = PHY_INTERFACE_MODE_RMII; } -#endif debug("%s, iobase=%x, priv=%p\n", __func__, iobase, priv); ioaddr = iobase;