From: Stefan Roese Date: Fri, 20 Nov 2015 12:39:43 +0000 (+0100) Subject: spi: kirkwood_spi.c: Add driver model support X-Git-Url: http://git.dujemihanovic.xyz/login.html?a=commitdiff_plain;h=9985bdb1cea7ba0b238f299d5bec591a144d3132;p=u-boot.git spi: kirkwood_spi.c: Add driver model support This patch adds driver model support to the kirkwood SPI driver. Which is also used on the MVEBU SoC's, now being converted to DM. Non-DM support is still available for the "older" platforms using this driver, like kirkwood. Signed-off-by: Stefan Roese Cc: Valentin Longchamp Cc: Luka Perkov Cc: Jagan Teki Cc: Simon Glass --- diff --git a/drivers/spi/kirkwood_spi.c b/drivers/spi/kirkwood_spi.c index 08bf4329e9..7890796b36 100644 --- a/drivers/spi/kirkwood_spi.c +++ b/drivers/spi/kirkwood_spi.c @@ -9,6 +9,7 @@ */ #include +#include #include #include #include @@ -18,6 +19,83 @@ #endif #include +static void _spi_cs_activate(struct kwspi_registers *reg) +{ + setbits_le32(®->ctrl, KWSPI_CSN_ACT); +} + +static void _spi_cs_deactivate(struct kwspi_registers *reg) +{ + clrbits_le32(®->ctrl, KWSPI_CSN_ACT); +} + +static int _spi_xfer(struct kwspi_registers *reg, unsigned int bitlen, + const void *dout, void *din, unsigned long flags) +{ + unsigned int tmpdout, tmpdin; + int tm, isread = 0; + + debug("spi_xfer: dout %p din %p bitlen %u\n", dout, din, bitlen); + + if (flags & SPI_XFER_BEGIN) + _spi_cs_activate(reg); + + /* + * handle data in 8-bit chunks + * TBD: 2byte xfer mode to be enabled + */ + clrsetbits_le32(®->cfg, KWSPI_XFERLEN_MASK, KWSPI_XFERLEN_1BYTE); + + while (bitlen > 4) { + debug("loopstart bitlen %d\n", bitlen); + tmpdout = 0; + + /* Shift data so it's msb-justified */ + if (dout) + tmpdout = *(u32 *)dout & 0xff; + + clrbits_le32(®->irq_cause, KWSPI_SMEMRDIRQ); + writel(tmpdout, ®->dout); /* Write the data out */ + debug("*** spi_xfer: ... %08x written, bitlen %d\n", + tmpdout, bitlen); + + /* + * Wait for SPI transmit to get out + * or time out (1 second = 1000 ms) + * The NE event must be read and cleared first + */ + for (tm = 0, isread = 0; tm < KWSPI_TIMEOUT; ++tm) { + if (readl(®->irq_cause) & KWSPI_SMEMRDIRQ) { + isread = 1; + tmpdin = readl(®->din); + debug("spi_xfer: din %p..%08x read\n", + din, tmpdin); + + if (din) { + *((u8 *)din) = (u8)tmpdin; + din += 1; + } + if (dout) + dout += 1; + bitlen -= 8; + } + if (isread) + break; + } + if (tm >= KWSPI_TIMEOUT) + printf("*** spi_xfer: Time out during SPI transfer\n"); + + debug("loopend bitlen %d\n", bitlen); + } + + if (flags & SPI_XFER_END) + _spi_cs_deactivate(reg); + + return 0; +} + +#ifndef CONFIG_DM_SPI + static struct kwspi_registers *spireg = (struct kwspi_registers *)MVEBU_SPI_BASE; @@ -145,16 +223,6 @@ void spi_init(void) { } -static void _spi_cs_activate(struct kwspi_registers *reg) -{ - setbits_le32(®->ctrl, KWSPI_CSN_ACT); -} - -static void _spi_cs_deactivate(struct kwspi_registers *reg) -{ - clrbits_le32(®->ctrl, KWSPI_CSN_ACT); -} - void spi_cs_activate(struct spi_slave *slave) { _spi_cs_activate(spireg); @@ -165,73 +233,101 @@ void spi_cs_deactivate(struct spi_slave *slave) _spi_cs_deactivate(spireg); } -static int _spi_xfer(struct kwspi_registers *reg, unsigned int bitlen, - const void *dout, void *din, unsigned long flags) +int spi_xfer(struct spi_slave *slave, unsigned int bitlen, + const void *dout, void *din, unsigned long flags) { - unsigned int tmpdout, tmpdin; - int tm, isread = 0; + return _spi_xfer(spireg, bitlen, dout, din, flags); +} - debug("spi_xfer: dout %p din %p bitlen %u\n", dout, din, bitlen); +#else - if (flags & SPI_XFER_BEGIN) - _spi_cs_activate(reg); +/* Here now the DM part */ - /* - * handle data in 8-bit chunks - * TBD: 2byte xfer mode to be enabled - */ - clrsetbits_le32(®->cfg, KWSPI_XFERLEN_MASK, KWSPI_XFERLEN_1BYTE); +struct mvebu_spi_platdata { + struct kwspi_registers *spireg; +}; - while (bitlen > 4) { - debug("loopstart bitlen %d\n", bitlen); - tmpdout = 0; +struct mvebu_spi_priv { + struct kwspi_registers *spireg; +}; - /* Shift data so it's msb-justified */ - if (dout) - tmpdout = *(u32 *)dout & 0xff; +static int mvebu_spi_set_speed(struct udevice *bus, uint hz) +{ + struct mvebu_spi_platdata *plat = dev_get_platdata(bus); + struct kwspi_registers *reg = plat->spireg; + u32 data; - clrbits_le32(®->irq_cause, KWSPI_SMEMRDIRQ); - writel(tmpdout, ®->dout); /* Write the data out */ - debug("*** spi_xfer: ... %08x written, bitlen %d\n", - tmpdout, bitlen); + /* calculate spi clock prescaller using max_hz */ + data = ((CONFIG_SYS_TCLK / 2) / hz) + 0x10; + data = data < KWSPI_CLKPRESCL_MIN ? KWSPI_CLKPRESCL_MIN : data; + data = data > KWSPI_CLKPRESCL_MASK ? KWSPI_CLKPRESCL_MASK : data; - /* - * Wait for SPI transmit to get out - * or time out (1 second = 1000 ms) - * The NE event must be read and cleared first - */ - for (tm = 0, isread = 0; tm < KWSPI_TIMEOUT; ++tm) { - if (readl(®->irq_cause) & KWSPI_SMEMRDIRQ) { - isread = 1; - tmpdin = readl(®->din); - debug("spi_xfer: din %p..%08x read\n", - din, tmpdin); + /* program spi clock prescaler using max_hz */ + writel(KWSPI_ADRLEN_3BYTE | data, ®->cfg); + debug("data = 0x%08x\n", data); - if (din) { - *((u8 *)din) = (u8)tmpdin; - din += 1; - } - if (dout) - dout += 1; - bitlen -= 8; - } - if (isread) - break; - } - if (tm >= KWSPI_TIMEOUT) - printf("*** spi_xfer: Time out during SPI transfer\n"); + return 0; +} - debug("loopend bitlen %d\n", bitlen); - } +static int mvebu_spi_set_mode(struct udevice *bus, uint mode) +{ + return 0; +} - if (flags & SPI_XFER_END) - _spi_cs_deactivate(reg); +static int mvebu_spi_xfer(struct udevice *dev, unsigned int bitlen, + const void *dout, void *din, unsigned long flags) +{ + struct udevice *bus = dev->parent; + struct mvebu_spi_platdata *plat = dev_get_platdata(bus); + + return _spi_xfer(plat->spireg, bitlen, dout, din, flags); +} + +static int mvebu_spi_probe(struct udevice *bus) +{ + struct mvebu_spi_platdata *plat = dev_get_platdata(bus); + struct kwspi_registers *reg = plat->spireg; + + writel(KWSPI_SMEMRDY, ®->ctrl); + writel(KWSPI_SMEMRDIRQ, ®->irq_cause); + writel(KWSPI_IRQMASK, ®->irq_mask); return 0; } -int spi_xfer(struct spi_slave *slave, unsigned int bitlen, - const void *dout, void *din, unsigned long flags) +static int mvebu_spi_ofdata_to_platdata(struct udevice *bus) { - return _spi_xfer(spireg, bitlen, dout, din, flags); + struct mvebu_spi_platdata *plat = dev_get_platdata(bus); + + plat->spireg = (struct kwspi_registers *)dev_get_addr(bus); + + return 0; } + +static const struct dm_spi_ops mvebu_spi_ops = { + .xfer = mvebu_spi_xfer, + .set_speed = mvebu_spi_set_speed, + .set_mode = mvebu_spi_set_mode, + /* + * cs_info is not needed, since we require all chip selects to be + * in the device tree explicitly + */ +}; + +static const struct udevice_id mvebu_spi_ids[] = { + { .compatible = "marvell,armada-380-spi" }, + { .compatible = "marvell,armada-xp-spi" }, + { } +}; + +U_BOOT_DRIVER(mvebu_spi) = { + .name = "mvebu_spi", + .id = UCLASS_SPI, + .of_match = mvebu_spi_ids, + .ops = &mvebu_spi_ops, + .ofdata_to_platdata = mvebu_spi_ofdata_to_platdata, + .platdata_auto_alloc_size = sizeof(struct mvebu_spi_platdata), + .priv_auto_alloc_size = sizeof(struct mvebu_spi_priv), + .probe = mvebu_spi_probe, +}; +#endif