From: pekon gupta Date: Thu, 5 Dec 2013 12:24:21 +0000 (+0530) Subject: mtd: nand: omap: fix ecc-layout for HAM1 ecc-scheme X-Git-Url: http://git.dujemihanovic.xyz/login.html?a=commitdiff_plain;h=69cc97f8dbf898d732fbd04852cf1068aeb991ba;p=u-boot.git mtd: nand: omap: fix ecc-layout for HAM1 ecc-scheme As per OMAP3530 TRM referenced below [1] For large-page NAND, ROM code expects following ecc-layout for HAM1 ecc-scheme - OOB[1] (offset of 1 *byte* from start of OOB) for x8 NAND device - OOB[2] (offset of 1 *word* from start of OOB) for x16 NAND device Thus ecc-layout expected by ROM code for HAM1 ecc-scheme is: *for x8 NAND Device* +--------+---------+---------+---------+---------+---------+---------+ | xxxx | ECC[A0] | ECC[A1] | ECC[A2] | ECC[B0] | ECC[B1] | ECC[B2] | ... +--------+---------+---------+---------+---------+---------+---------+ *for x16 NAND Device* +--------+--------+---------+---------+---------+---------+---------+---------+ | xxxxx | xxxxx | ECC[A0] | ECC[A1] | ECC[A2] | ECC[B0] | ECC[B1] | ECC[B2] | +--------+--------+---------+---------+---------+---------+---------+---------+ This patch fixes ecc-layout *only* for HAM1, as required by ROM-code For other ecc-schemes like (BCH8) ecc-layout is same for x8 or x16 devices. [1] OMAP3530: http://www.ti.com/product/omap3530 TRM: http://www.ti.com/litv/pdf/spruf98x Chapter-25: Initialization Sub-topic: Memory Booting Section: 25.4.7.4 NAND Figure 25-19. ECC Locations in NAND Spare Areas Reported-by: Stefan Roese Signed-off-by: Pekon Gupta Tested-by: Stefan Roese --- diff --git a/drivers/mtd/nand/omap_gpmc.c b/drivers/mtd/nand/omap_gpmc.c index 5e7e6b3375..23a961c9d4 100644 --- a/drivers/mtd/nand/omap_gpmc.c +++ b/drivers/mtd/nand/omap_gpmc.c @@ -798,8 +798,12 @@ static int omap_select_ecc_scheme(struct nand_chip *nand, nand->ecc.calculate = omap_calculate_ecc; /* define ecc-layout */ ecclayout->eccbytes = nand->ecc.bytes * eccsteps; - for (i = 0; i < ecclayout->eccbytes; i++) - ecclayout->eccpos[i] = i + BADBLOCK_MARKER_LENGTH; + for (i = 0; i < ecclayout->eccbytes; i++) { + if (nand->options & NAND_BUSWIDTH_16) + ecclayout->eccpos[i] = i + 2; + else + ecclayout->eccpos[i] = i + 1; + } ecclayout->oobfree[0].offset = i + BADBLOCK_MARKER_LENGTH; ecclayout->oobfree[0].length = oobsize - ecclayout->eccbytes - BADBLOCK_MARKER_LENGTH;