From: Dhruva Gole Date: Tue, 3 Jan 2023 06:31:11 +0000 (+0530) Subject: spi: cadence_qspi: setup ADDR Bits in cmd reads X-Git-Url: http://git.dujemihanovic.xyz/login.html?a=commitdiff_plain;h=2330af2722d1b5f0772538b0a5cede217a331638;p=u-boot.git spi: cadence_qspi: setup ADDR Bits in cmd reads Setup the Addr bit field while issuing register reads in STIG mode. This is needed for example flashes like cypress define in their transaction table that to read any register there is 1 cmd byte and a few more address bytes trailing the cmd byte. Absence of addr bytes will obviously fail to read correct data from flash register that maybe requested by flash driver because the controller doesn't even specify which address of the flash register the read is being requested from. Signed-off-by: Dhruva Gole Reviewed-by: Pratyush Yadav Reviewed-by: Jagan Teki --- diff --git a/drivers/spi/cadence_qspi_apb.c b/drivers/spi/cadence_qspi_apb.c index d1f89138ef..21fe2e655c 100644 --- a/drivers/spi/cadence_qspi_apb.c +++ b/drivers/spi/cadence_qspi_apb.c @@ -479,6 +479,19 @@ int cadence_qspi_apb_command_read(struct cadence_spi_priv *priv, /* 0 means 1 byte. */ reg |= (((rxlen - 1) & CQSPI_REG_CMDCTRL_RD_BYTES_MASK) << CQSPI_REG_CMDCTRL_RD_BYTES_LSB); + + /* setup ADDR BIT field */ + if (op->addr.nbytes) { + writel(op->addr.val, priv->regbase + CQSPI_REG_CMDADDRESS); + /* + * address bytes are zero indexed + */ + reg |= (((op->addr.nbytes - 1) & + CQSPI_REG_CMDCTRL_ADD_BYTES_MASK) << + CQSPI_REG_CMDCTRL_ADD_BYTES_LSB); + reg |= (0x1 << CQSPI_REG_CMDCTRL_ADDR_EN_LSB); + } + status = cadence_qspi_apb_exec_flash_cmd(reg_base, reg); if (status != 0) return status;