armv7R: K3: am654: Use full malloc in SPL both pre and post reloc

In order to be able to use things like file system drivers early on in
SPL (before relocation) in a memory-constrained environment when DDR is
not yet available we cannot use the simple malloc scheme which does not
implement the freeing of previously allocated memory blocks. To address
this issue go ahead and enable the use of the full malloc by manually
initializing the required functionality inside board_init_f by creating
a full malloc pool inside the pre-relocation malloc pool.

Signed-off-by: Faiz Abbas <faiz_abbas@ti.com>

diff --git a/arch/arm/mach-k3/am6_init.c b/arch/arm/mach-k3/am6_init.c
index 516a02e8a899e87ba1ee8b9d6c4c182c6ea8a09a..74557c4bb7ccd52e02f71279f6d649aa0ee07232 100644 (file)
--- a/arch/arm/mach-k3/am6_init.c
+++ b/arch/arm/mach-k3/am6_init.c
@@ -18,7 +18,9 @@
 #include <dm/uclass-internal.h>
 #include <dm/pinctrl.h>
 #include <linux/soc/ti/ti_sci_protocol.h>
+#include <log.h>
 #include <mmc.h>
+#include <stdlib.h>
 
 #ifdef CONFIG_SPL_BUILD
 #ifdef CONFIG_K3_LOAD_SYSFW
@@ -119,6 +121,8 @@ void board_init_f(ulong dummy)
 {
 #if defined(CONFIG_K3_LOAD_SYSFW) || defined(CONFIG_K3_AM654_DDRSS)
        struct udevice *dev;
+       size_t pool_size;
+       void *pool_addr;
        int ret;
 #endif
        /*
@@ -149,6 +153,20 @@ void board_init_f(ulong dummy)
 #endif
 
 #ifdef CONFIG_K3_LOAD_SYSFW
+       /*
+        * Initialize an early full malloc environment. Do so by allocating a
+        * new malloc area inside the currently active pre-relocation "first"
+        * malloc pool of which we use all that's left.
+        */
+       pool_size = CONFIG_VAL(SYS_MALLOC_F_LEN) - gd->malloc_ptr;
+       pool_addr = malloc(pool_size);
+       if (!pool_addr)
+               panic("ERROR: Can't allocate full malloc pool!\n");
+
+       mem_malloc_init((ulong)pool_addr, (ulong)pool_size);
+       gd->flags |= GD_FLG_FULL_MALLOC_INIT;
+       debug("%s: initialized an early full malloc pool at 0x%08lx of 0x%lx bytes\n",
+             __func__, (unsigned long)pool_addr, (unsigned long)pool_size);
        /*
         * Process pinctrl for the serial0 a.k.a. WKUP_UART0 module and continue
         * regardless of the result of pinctrl. Do this without probing the