Merge patch series "spi-nor: Add parallel and stacked memories support"

Venkatesh Yadav Abbarapu <venkatesh.abbarapu@amd.com> says:

This series adds support for Xilinx qspi parallel and
stacked memeories.

In parallel mode, the current implementation assumes that a maximum
of two flashes are connected. The QSPI controller splits the data
evenly between both the flashes so, both the flashes that are connected
in parallel mode should be identical.
During each operation SPI-NOR sets 0th bit for CS0 & 1st bit for CS1 in
nor->flags.

In stacked mode the current implementation assumes that a maximum of two
flashes are connected and both the flashes are of same make but can differ
in sizes. So, except the sizes all other flash parameters of both the flashes
are identical.

Spi-nor will pass on the appropriate flash select flag to low level driver,
and it will select pass all the data to that particular flash.

Write operation in parallel mode are performed in page size * 2 chunks as
each write operation results in writing both the flashes. For doubling the
address space each operation is performed at addr/2 flash offset, where addr
is the address specified by the user.

Similarly for read and erase operations it will read from both flashes, so
size and offset are divided by 2 and send to flash.

diff --cc configs/xilinx_versal_net_virt_defconfig
Simple merge

diff --cc configs/xilinx_versal_virt_defconfig
Simple merge

diff --cc configs/xilinx_zynq_virt_defconfig
Simple merge

diff --cc configs/xilinx_zynqmp_virt_defconfig
Simple merge

diff --cc drivers/spi/davinci_spi.c
Simple merge