armv8: ls1012a: RGMII ports require internal delay

The correct setting for the RGMII ports on LS1012ARDB is to
enable delay on both Rx and Tx so the interface mode used should
be PHY_INTERFACE_MODE_RGMII_ID

Signed-off-by: Chaitanya Sakinam <chaitanya.sakinam@nxp.com>
Signed-off-by: Anji J <anji.jagarlmudi@nxp.com>
Reviewed-by: Priyanka Jain <priyanka.jain@nxp.com>

diff --git a/board/freescale/ls1012ardb/eth.c b/board/freescale/ls1012ardb/eth.c
index 63d40de2a3ec936e3aa10fdea370f0540d40a45d..a65ff4dc9c4f6e335452900da92f45300602746d 100644 (file)
--- a/board/freescale/ls1012ardb/eth.c
+++ b/board/freescale/ls1012ardb/eth.c
@@ -113,7 +113,7 @@ int pfe_eth_board_init(struct udevice *dev)
                        /* MAC2 */
                        pfe_set_phy_address_mode(priv->gemac_port,
                                                 CONFIG_PFE_EMAC2_PHY_ADDR,
-                                                PHY_INTERFACE_MODE_RGMII_TXID);
+                                                PHY_INTERFACE_MODE_RGMII_ID);
                }
                break;
        case 0x2208:

diff --git a/drivers/net/pfe_eth/pfe_eth.c b/drivers/net/pfe_eth/pfe_eth.c
index 718e24f14d357d15d86bf565be567e7b9853bc0d..e49bf4a6f3cf5dfc061eff3a5326960aabd50138 100644 (file)
--- a/drivers/net/pfe_eth/pfe_eth.c
+++ b/drivers/net/pfe_eth/pfe_eth.c
@@ -33,7 +33,7 @@ struct gemac_s gem_info[] = {
 
                /* phy iface */
                .phy_address = CONFIG_PFE_EMAC2_PHY_ADDR,
-               .phy_mode = PHY_INTERFACE_MODE_RGMII_TXID,
+               .phy_mode = PHY_INTERFACE_MODE_RGMII_ID,
        },
 };