spi: dw: Remove spi_enable_chip

This function does nothing but wrap dw_write.

Signed-off-by: Sean Anderson <seanga2@gmail.com>
Reviewed-by: Jagan Teki <jagan@amarulasolutions.com>

diff --git a/drivers/spi/designware_spi.c b/drivers/spi/designware_spi.c
index 8abcdde8a396093a31f0016f1c3c97e6abb53331..89a826605287fa7d6ff3b7818165ba258aaf24e2 100644 (file)
--- a/drivers/spi/designware_spi.c
+++ b/drivers/spi/designware_spi.c
@@ -171,17 +171,12 @@ static int dw_spi_ofdata_to_platdata(struct udevice *bus)
        return request_gpio_cs(bus);
 }
 
-static inline void spi_enable_chip(struct dw_spi_priv *priv, int enable)
-{
-       dw_write(priv, DW_SPI_SSIENR, (enable ? 1 : 0));
-}
-
 /* Restart the controller, disable all interrupts, clean rx fifo */
 static void spi_hw_init(struct udevice *bus, struct dw_spi_priv *priv)
 {
-       spi_enable_chip(priv, 0);
+       dw_write(priv, DW_SPI_SSIENR, 0);
        dw_write(priv, DW_SPI_IMR, 0xff);
-       spi_enable_chip(priv, 1);
+       dw_write(priv, DW_SPI_SSIENR, 1);
 
        /*
         * Try to detect the FIFO depth if not set by interface driver,
@@ -438,7 +433,7 @@ static int dw_spi_xfer(struct udevice *dev, unsigned int bitlen,
        priv->rx_end = priv->rx + priv->len;
 
        /* Disable controller before writing control registers */
-       spi_enable_chip(priv, 0);
+       dw_write(priv, DW_SPI_SSIENR, 0);
 
        dev_dbg(dev, "cr0=%08x rx=%p tx=%p len=%d [bytes]\n", cr0, rx, tx,
                priv->len);
@@ -455,7 +450,7 @@ static int dw_spi_xfer(struct udevice *dev, unsigned int bitlen,
        dw_write(priv, DW_SPI_SER, 1 << cs);
 
        /* Enable controller after writing control registers */
-       spi_enable_chip(priv, 1);
+       dw_write(priv, DW_SPI_SSIENR, 1);
 
        /* Start transfer in a polling loop */
        ret = poll_transfer(priv);
@@ -490,7 +485,7 @@ static int dw_spi_set_speed(struct udevice *bus, uint speed)
                speed = plat->frequency;
 
        /* Disable controller before writing control registers */
-       spi_enable_chip(priv, 0);
+       dw_write(priv, DW_SPI_SSIENR, 0);
 
        /* clk_div doesn't support odd number */
        clk_div = priv->bus_clk_rate / speed;
@@ -498,7 +493,7 @@ static int dw_spi_set_speed(struct udevice *bus, uint speed)
        dw_write(priv, DW_SPI_BAUDR, clk_div);
 
        /* Enable controller after writing control registers */
-       spi_enable_chip(priv, 1);
+       dw_write(priv, DW_SPI_SSIENR, 1);
 
        priv->freq = speed;
        dev_dbg(bus, "speed=%d clk_div=%d\n", priv->freq, clk_div);