board: freescale: p1_p2_rdb_pc: Move ifdef for USB/eLBC check to correct place

Whole section about USB/eLBC configuration seems to be P1020 specific. So
add ifdefs to not compile it on other platforms (e.g. P2020).

Signed-off-by: Pali Rohár <pali@kernel.org>
Reviewed-by: Priyanka Jain <priyanka.jain@nxp.com>

diff --git a/board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c b/board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c
index bed2033e36f80621277c52ccda19ccc73cc53e45..6665aa4ba94e8c5c6e07820a82e816b46a435b8b 100644 (file)
--- a/board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c
+++ b/board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c
@@ -359,9 +359,9 @@ int ft_board_setup(void *blob, struct bd_info *bd)
 #if defined(CONFIG_TARGET_P1020RDB_PD) || defined(CONFIG_TARGET_P1020RDB_PC)
        const char *soc_usb_compat = "fsl-usb2-dr";
        int usb_err, usb1_off, usb2_off;
-#endif
 #if defined(CONFIG_SDCARD) || defined(CONFIG_SPIFLASH)
        int err;
+#endif
 #endif
 
        ft_cpu_setup(blob, bd);
@@ -380,6 +380,7 @@ int ft_board_setup(void *blob, struct bd_info *bd)
        fsl_fdt_fixup_dr_usb(blob, bd);
 #endif
 
+#if defined(CONFIG_TARGET_P1020RDB_PD) || defined(CONFIG_TARGET_P1020RDB_PC)
 #if defined(CONFIG_SDCARD) || defined(CONFIG_SPIFLASH)
        /* Delete eLBC node as it is muxed with USB2 controller */
        if (hwconfig("usb2")) {
@@ -401,7 +402,6 @@ int ft_board_setup(void *blob, struct bd_info *bd)
        }
 #endif
 
-#if defined(CONFIG_TARGET_P1020RDB_PD) || defined(CONFIG_TARGET_P1020RDB_PC)
 /* Delete USB2 node as it is muxed with eLBC */
        usb1_off = fdt_node_offset_by_compatible(blob, -1,
                soc_usb_compat);