rockchip: Fix TPL build without CONFIG_TPL_SERIAL_SUPPORT

If CONFIG_DEBUG_UART is set but CONFIG_TPL_SERIAL_SUPPORT is not, the
serial output should be available in SPL and full U-Boot, but not built
in TPL. However, the rockchip tpl.c instead fails to compile with
undefined references to the debug UART.

Instead, initialise the debug UART and print the TPL banner only if both
CONFIG_DEBUG_UART and CONFIG_TPL_SERIAL_SUPPORT are set.

Signed-off-by: <chris@arachsys.com>
Reviewed-by: Kever Yang <Kever.yang@rock-chips.com>

diff --git a/arch/arm/mach-rockchip/tpl.c b/arch/arm/mach-rockchip/tpl.c
index 0ff2a197edb224c464a518d9754142d8eddf035d..5df88bddeb289f360843140d71bc44a4a86c4c70 100644 (file)
--- a/arch/arm/mach-rockchip/tpl.c
+++ b/arch/arm/mach-rockchip/tpl.c
@@ -44,7 +44,7 @@ void board_init_f(ulong dummy)
        struct udevice *dev;
        int ret;
 
-#ifdef CONFIG_DEBUG_UART
+#if defined(CONFIG_DEBUG_UART) && defined(CONFIG_TPL_SERIAL_SUPPORT)
        /*
         * Debug UART can be used from here if required:
         *