sunxi: Pine-H64: Explicitly enable PHY regulator

According to the devicetree and the schematic, the 3.3V power rail for
the PHY is enabled by GPIO PC16. It's wired as active-high, with a
pull-up resistor, so actually works already when the GPIO is in
High-Z state.

However we should not take any chances and explicitly set the GPIO pin
to high, to avoid accidentally losing the PHY power.
The existing MACPWR Kconfig allows to do this easily.

Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Acked-by: Maxime Ripard <mripard@kernel.org>
Tested-by: Amit Singh Tomar <amittomer25@gmail.com> # Pine64+
Reviewed-by: Jagan Teki <jagan@amarulasolutions.com>

diff --git a/configs/pine_h64_defconfig b/configs/pine_h64_defconfig
index 328849d7243f9dd1d8139854046e871b26f40ea8..07ad31e3a7076f8625204114e94431c69e1bdb31 100644 (file)
--- a/configs/pine_h64_defconfig
+++ b/configs/pine_h64_defconfig
@@ -11,5 +11,6 @@ CONFIG_SPL_SPI_SUNXI=y
 CONFIG_DEFAULT_DEVICE_TREE="sun50i-h6-pine-h64"
 # CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
 CONFIG_SUN8I_EMAC=y
+CONFIG_MACPWR="PC16"
 CONFIG_USB_EHCI_HCD=y
 CONFIG_USB_OHCI_HCD=y