acpi: Add a binding for ACPI settings in the device tree

Devices need to report various identifiers in the ACPI tables. Rather than
hard-coding these in drivers it is typically better to put them in the
device tree.

Add a binding file to describe this.

Signed-off-by: Simon Glass <sjg@chromium.org>

diff --git a/doc/device-tree-bindings/device.txt b/doc/device-tree-bindings/device.txt
new file mode 100644 (file)
index 0000000..27bd397
--- /dev/null
+++ b/doc/device-tree-bindings/device.txt
@@ -0,0 +1,36 @@
+Devices
+=======
+
+Device bindings are described by their own individual binding files.
+
+U-Boot provides for some optional properties which are documented here. See
+also hid-over-i2c.txt which describes HID devices. See also
+Documentation/firmware-guide/acpi/enumeration.rst in the Linux kernel for
+the acpi,compatible property.
+
+ - acpi,has-power-resource : (boolean) true if this device has a power resource.
+    This causes an ACPI PowerResource to be written containing the properties
+    provided by this binding, to describe how to handle powering the device up
+    and down using GPIOs
+ - acpi,compatible : compatible string to report
+ - acpi,ddn : Contains the string to use as the _DDN (DOS (Disk Operating
+    System) Device Name)
+ - acpi,hid : Contains the string to use as the HID (Hardware ID)
+    identifier _HID
+ - acpi,uid : _UID value for device
+ - linux,probed : Tells U-Boot to add 'linux,probed' to the ACPI tables so that
+    Linux will only load the driver if the device can be detected (e.g. on I2C
+    bus). Note that this is an out-of-tree Linux feature.
+
+
+Example
+-------
+
+elan_touchscreen: elan-touchscreen@10 {
+       compatible = "i2c-chip";
+       reg = <0x10>;
+       acpi,hid = "ELAN0001";
+       acpi,ddn = "ELAN Touchscreen";
+       interrupts-extended = <&acpi_gpe GPIO_21_IRQ IRQ_TYPE_EDGE_FALLING>;
+       linux,probed;
+};