From: Tero Kristo Date: Fri, 11 Jun 2021 08:45:20 +0000 (+0300) Subject: arm: mach-k3: do board config for PM only if supported X-Git-Url: http://git.dujemihanovic.xyz/img/static/git-favicon.png?a=commitdiff_plain;h=0714580346cc0b3999d62e0949b17561a965a24b;p=u-boot.git arm: mach-k3: do board config for PM only if supported If the raw PM support is built in, we are operating in the split firmware approach mode where PM support is not available. In this case, skip the board config for this. Signed-off-by: Tero Kristo Signed-off-by: Tero Kristo --- diff --git a/arch/arm/mach-k3/sysfw-loader.c b/arch/arm/mach-k3/sysfw-loader.c index 0bacfc4d07..41449db89d 100644 --- a/arch/arm/mach-k3/sysfw-loader.c +++ b/arch/arm/mach-k3/sysfw-loader.c @@ -159,11 +159,13 @@ static void k3_sysfw_configure_using_fit(void *fit, ret); /* Apply power/clock (PM) specific configuration to SYSFW */ +#if !CONFIG_IS_ENABLED(K3_DM_FW) ret = board_ops->board_config_pm(ti_sci, (u64)(u32)cfg_fragment_addr, (u32)cfg_fragment_size); if (ret) panic("Failed to set board PM configuration (%d)\n", ret); +#endif /* Extract resource management (RM) specific configuration from FIT */ ret = fit_get_data_by_name(fit, images, SYSFW_CFG_RM,