pinctrl: rockchip: Fix drive and input schmitt on RK3568

On RK3568 most pins have a configurable drive strength of level 0-5 and
some pins level 0-11. When rk3568_set_drive is called with a strength
value above 7 the drv value written to reg may overflow into the write
enable bits, resulting in a bad configuration.

This cause e.g. ethernet PHY on Radxa CM3-IO board not to work after
drive is configured according to the device tree.

  Could not get PHY for ethernet@fe010000: addr 0

Level 6-11 can be configured using a second reg for some pins, however
the drv value is reused resulting in lower 6 bits being written to reg.

Input schmitt is configured in 2-bit fields on RK3568 compared to
earlier generation and 2'b10 should be used to enable input schmitt.

Change to use regmap_update_bits with a rmask to fix the overflow issue
and closer match the linux driver. Bit shift the drv value used for the
second reg to configure drive strength level 6-11. Also write correct
values for input schmitt setting.

Fixes: 1977d746aa54 ("rockchip: rk3568: add rk3568 pinctrl driver")
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Simon Glass <sjg@chromium.org>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>

diff --git a/drivers/pinctrl/rockchip/pinctrl-rk3568.c b/drivers/pinctrl/rockchip/pinctrl-rk3568.c
index 314edb5a60648e0e7069fdb5f397fcc42510b370..1d439198260541bfd7542239ab339a042a27c21a 100644 (file)
--- a/drivers/pinctrl/rockchip/pinctrl-rk3568.c
+++ b/drivers/pinctrl/rockchip/pinctrl-rk3568.c
@@ -113,11 +113,9 @@ static int rk3568_set_mux(struct rockchip_pin_bank *bank, int pin, int mux)
        struct rockchip_pinctrl_priv *priv = bank->priv;
        int iomux_num = (pin / 8);
        struct regmap *regmap;
-       int reg, ret, mask;
+       int reg, mask;
        u8 bit;
-       u32 data;
-
-       debug("setting mux of GPIO%d-%d to %d\n", bank->bank_num, pin, mux);
+       u32 data, rmask;
 
        if (bank->iomux[iomux_num].type & IOMUX_SOURCE_PMU)
                regmap = priv->regmap_pmu;
@@ -131,10 +129,10 @@ static int rk3568_set_mux(struct rockchip_pin_bank *bank, int pin, int mux)
        mask = 0xf;
 
        data = (mask << (bit + 16));
+       rmask = data | (data >> 16);
        data |= (mux & mask) << bit;
-       ret = regmap_write(regmap, reg, data);
 
-       return ret;
+       return regmap_update_bits(regmap, reg, rmask, data);
 }
 
 #define RK3568_PULL_PMU_OFFSET         0x20
@@ -225,7 +223,7 @@ static int rk3568_set_pull(struct rockchip_pin_bank *bank,
        struct regmap *regmap;
        int reg, ret;
        u8 bit, type;
-       u32 data;
+       u32 data, rmask;
 
        if (pull == PIN_CONFIG_BIAS_PULL_PIN_DEFAULT)
                return -ENOTSUPP;
@@ -249,52 +247,59 @@ static int rk3568_set_pull(struct rockchip_pin_bank *bank,
 
        /* enable the write to the equivalent lower bits */
        data = ((1 << ROCKCHIP_PULL_BITS_PER_PIN) - 1) << (bit + 16);
-
+       rmask = data | (data >> 16);
        data |= (ret << bit);
-       ret = regmap_write(regmap, reg, data);
 
-       return ret;
+       return regmap_update_bits(regmap, reg, rmask, data);
 }
 
+#define GRF_GPIO1C5_DS         0x0840
+#define GRF_GPIO2A2_DS         0x0844
+#define GRF_GPIO2B0_DS         0x0848
+#define GRF_GPIO3A0_DS         0x084c
+#define GRF_GPIO3A6_DS         0x0850
+#define GRF_GPIO4A0_DS         0x0854
+
 static int rk3568_set_drive(struct rockchip_pin_bank *bank,
                            int pin_num, int strength)
 {
        struct regmap *regmap;
-       int reg;
-       u32 data;
+       int reg, ret;
+       u32 data, rmask;
        u8 bit;
        int drv = (1 << (strength + 1)) - 1;
-       int ret = 0;
 
        rk3568_calc_drv_reg_and_bit(bank, pin_num, &regmap, &reg, &bit);
 
        /* enable the write to the equivalent lower bits */
        data = ((1 << RK3568_DRV_BITS_PER_PIN) - 1) << (bit + 16);
+       rmask = data | (data >> 16);
        data |= (drv << bit);
 
-       ret = regmap_write(regmap, reg, data);
+       ret = regmap_update_bits(regmap, reg, rmask, data);
        if (ret)
                return ret;
 
        if (bank->bank_num == 1 && pin_num == 21)
-               reg = 0x0840;
+               reg = GRF_GPIO1C5_DS;
        else if (bank->bank_num == 2 && pin_num == 2)
-               reg = 0x0844;
+               reg = GRF_GPIO2A2_DS;
        else if (bank->bank_num == 2 && pin_num == 8)
-               reg = 0x0848;
+               reg = GRF_GPIO2B0_DS;
        else if (bank->bank_num == 3 && pin_num == 0)
-               reg = 0x084c;
+               reg = GRF_GPIO3A0_DS;
        else if (bank->bank_num == 3 && pin_num == 6)
-               reg = 0x0850;
+               reg = GRF_GPIO3A6_DS;
        else if (bank->bank_num == 4 && pin_num == 0)
-               reg = 0x0854;
+               reg = GRF_GPIO4A0_DS;
        else
                return 0;
 
        data = ((1 << RK3568_DRV_BITS_PER_PIN) - 1) << 16;
-       data |= drv;
+       rmask = data | (data >> 16);
+       data |= drv >> 6;
 
-       return regmap_write(regmap, reg, data);
+       return regmap_update_bits(regmap, reg, rmask, data);
 }
 
 static int rk3568_set_schmitt(struct rockchip_pin_bank *bank,
@@ -302,16 +307,17 @@ static int rk3568_set_schmitt(struct rockchip_pin_bank *bank,
 {
        struct regmap *regmap;
        int reg;
-       u32 data;
+       u32 data, rmask;
        u8 bit;
 
        rk3568_calc_schmitt_reg_and_bit(bank, pin_num, &regmap, &reg, &bit);
 
        /* enable the write to the equivalent lower bits */
        data = ((1 << RK3568_SCHMITT_BITS_PER_PIN) - 1) << (bit + 16);
-       data |= (enable << bit);
+       rmask = data | (data >> 16);
+       data |= ((enable ? 0x2 : 0x1) << bit);
 
-       return regmap_write(regmap, reg, data);
+       return regmap_update_bits(regmap, reg, rmask, data);
 }
 
 static struct rockchip_pin_bank rk3568_pin_banks[] = {