]> git.dujemihanovic.xyz Git - u-boot.git/shortlog
u-boot.git
2013-02-11 Allen Martintegra: add addresses of SPI SLINK controllers
2013-02-11 Allen Martintegra30: fdt: add SPI SLINK nodes
2013-02-11 Allen Martintegra30: add SBC1 to periph id mapping table
2013-02-11 Allen Martintegra: spi: add fdt support to tegra SPI SFLASH driver
2013-02-11 Allen Martintegra20: fdt: add SPI SFLASH node
2013-02-11 Stephen Warrentegra: don't hard-code LCD into default TEGRA_DEVICE_SE...
2013-02-11 Stephen Warrentegra: rename FUNCMUX_UART2_UARTB
2013-02-11 Tom WarrenTegra: Move common clock code to arch/arm/cpu/tegra...
2013-02-11 Tom WarrenTegra: T20: Remove unused 'SLOW' SoC ID and PLLX table...
2013-02-11 Allen Martintegra: fdt: add back missing host1x node
2013-02-07 Tom Riniam33xx: Drop gpio0_7_pin_mux from phytec pcm051
2013-02-07 Javier Martinez... OMAP3: igep00x0: fix a build warning on IGEP boards
2013-02-07 hvaibhav@ti.comAM335X: Set fdt_high for AM335X devices to enable booti...
2013-02-07 Jeff LanceAdd DDR3 support for AM335x-EVM (Version 1.5A)
2013-02-07 Lars Poeschelam335x: display msg when reading MAC from efuse
2013-02-07 Lars Poeschelpcm051: Add support for Phytec phyCORE-AM335x
2013-02-07 Lars Poeschelam33xx: add a pulldown macro to pinmux config
2013-02-07 Javier Martinez... omap4: allow the use of a plain text env file instead...
2013-02-07 Javier Martinez... OMAP3: igep00x0: add boot status GPIO LED
2013-02-07 Javier Martinez... OMAP3: use a single board file for IGEP devices
2013-02-03 Rob HerringARM: highbank: use wfi macro instead of inline asm
2013-02-03 Rob HerringARM: add wfi assembly macro
2013-02-02 Tetsuyuki Kobayashiarm: rmobile: kzm9g: Adjust ETM trace clock
2013-02-02 Tetsuyuki Kobayashiarm: rmobile: kzm9g: Adjust SDRAM setting
2013-02-02 Albert ARIBAUDMerge branch 'u-boot-imx/master' into 'u-boot-arm/master'
2013-01-28 Otavio Salvadormx23evk: Add initial board support
2013-01-28 Otavio Salvadormx23_olinuxino: Add default environment
2013-01-28 Marek Vasutmxs: mmc: mx23_olinuxino: Add MMC support
2013-01-28 Marek Vasutmxs: mmc: Fix the MMC driver for MX23
2013-01-28 Marek Vasutmxs: mmc: Allow overriding default card detect implemen...
2013-01-28 Otavio Salvadormxs: mmc: Fix MMC reset on iMX23
2013-01-28 Marek Vasutmxs: ssp: Add SSP registers map for MX23
2013-01-28 Marek Vasutmxs: dma: Fix APBH DMA driver for MX23
2013-01-28 Troy Kiskymx6qsabrelite: search mii phy address 4-7
2013-01-28 Troy Kiskynet: fec_mxc: get phydev before fec_probe
2013-01-28 Troy Kiskynet: fec_mxc: only call phy_connect in fec_probe
2013-01-28 Troy Kiskynet: fec_mxc: use fec_set_dev_name to set name
2013-01-28 Troy Kiskyphy: add phy_find_by_mask/phy_connect_dev
2013-01-28 Troy Kiskynet: fec_mxc: have fecmxc_initialize call fecmxc_initia...
2013-01-28 Troy Kiskynet: fec_mxc: change fec_mii_setspeed parameter
2013-01-28 Troy Kiskynet: fec_mxc: delete CONFIG_FEC_MXC_MULTI
2013-01-28 Troy Kiskydoc/README.fec_mxc: add documentation
2013-01-28 Fabio Estevammxs: Use __weak annotation to simplify code
2013-01-28 Fabio Estevamtools: imximage: Let .name field be more generic
2013-01-28 Fabio Estevammx6qsabre_common: Let mmc partition be board specific
2013-01-28 Knut Wohlrabmx6qsabreauto: enable USB host interface
2013-01-28 Marek Vasutmxs: Boost the memory power supply
2013-01-22 Troy Kiskyimximage.cfg: run files through C preprocessor
2013-01-21 Otavio Salvadormxs: Add MX23 quirks into the clock code
2013-01-21 Fabio Estevamwoodburn: Set Write Protection GPIO as input
2013-01-21 Marek Vasutmxs: Add MX23 olinuxino board support
2013-01-21 Marek Vasutmxs: Linux uses ttyAMA0 as DUART
2013-01-21 Otavio Salvadormxs: Fix the memory init for MX23
2013-01-21 Marek Vasutmxs: Add function to ungate the power block on MX23
2013-01-21 Marek Vasutmmc: Limit the number of used SSP ports on MX23
2013-01-21 Otavio Salvadormx23: config: Enable mxsboot tool for i.MX23 based...
2013-01-21 Otavio Salvadormx23: config: Enable building of u-boot.sb binary
2013-01-21 Otavio Salvadormx23: SPL: Initialize DDR at 133MHz
2013-01-21 Otavio Salvadormx23: SPL: Add boot mode support
2013-01-21 Otavio Salvadormx23: Add boot mode description
2013-01-21 Otavio Salvadormx23: Add support on print_cpuinfo()
2013-01-21 Marek Vasutmx23: ssp: Fix ssp-regs.h for MX23
2013-01-21 Marek Vasutmx23: Add POWER and CLKCTRL register definitions
2013-01-21 Otavio Salvadormx23: Add iomux-mx23.h
2013-01-21 Otavio Salvadormx23: Add register base addresses
2013-01-21 Otavio Salvadormxs: clock: Use 'mxs' prefix for methods
2013-01-21 Marek Vasutmxs: ssp: Pull out the SSP bus to regs conversion
2013-01-21 Marek Vasutmxs: mmc: Drop unused members from struct mxsmmc_priv
2013-01-17 Allen Martinfdt: fix dts preprocessor options
2013-01-17 Allen Martintegra: fdt: add apbdma node
2013-01-17 Allen Martintegra: fdt: sort dts files
2013-01-17 Allen Martintegra: fdt: remove clocks nodes
2013-01-16 Allen Martintegra: remove IRDA pinmux synonym
2013-01-16 Tom WarrenTegra30: I2C: Enable I2C driver on Cardhu
2013-01-16 Tom WarrenTegra30: fdt: Update DT files with I2C info for T30...
2013-01-16 Tom WarrenTegra30: clocks: Fix clock tables for I2C and other...
2013-01-16 Tom WarrenTegra30: Add/enable Cardhu build (T30 reference board)
2013-01-16 Tom WarrenTegra30: Add generic Tegra30 build support
2013-01-16 Tom WarrenTegra30: Cardhu: Add DT files
2013-01-16 Tom WarrenTegra30: Add common CPU (shared) files
2013-01-16 Tom WarrenTegra30: Add CPU (armv7) files
2013-01-16 Tom WarrenTegra30: Add AVP (arm720t) files
2013-01-16 Tom WarrenTegra30: Add arch-tegra30 include files
2013-01-16 Marc Dietrichtegra: remove custom TEGRA_DEVICE_SETTINGS for board...
2013-01-16 Marc Dietrichtegra: enable LCD on PAZ00
2013-01-16 Marc Dietrichtegra: display: add board pinmux
2013-01-16 Thierry Redingtegra: Enable LCD on TEC
2013-01-16 Thierry Redingtegra: Enable LCD on Medcom-Wide
2013-01-16 Thierry Redingvideo: tegra: Update line length to match resolution
2013-01-15 Tom RiniPrepare v2013.01
2013-01-14 Łukasz Dałekpxa: Save lr register in relocate_code function
2013-01-14 Tom RiniMerge branch 'master' of git://git.denx.de/u-boot-video
2013-01-14 Tom RiniMerge branch 'agust@denx.de' of git://git.denx.de/u...
2013-01-14 Peter Meerwaldtwl4030: fix 'could could' in error messages
2013-01-14 Tom Riniwatchdog.h: Move hw_watchdog_init prototype to end...
2013-01-14 Wolfgang DenkVIDEO: better document the correct use of CONFIG_FB_ADDR
2013-01-14 Nikita Kiryanovlcd: restore ability to display 8 bpp BMPs on 16 bpp...
2013-01-14 Albert ARIBAUDMerge branch 'u-boot-imx/master' into 'u-boot-arm/master'
2013-01-14 Albert ARIBAUDMerge branch 'u-boot-samsung/master' into 'u-boot-arm...
2013-01-14 Ajay Kumarvideo: exynos_fb: Make a call to draw_logo only when...
next