From 9c27ce781dd3fa9b7a5c42a34bf44f702756b30f Mon Sep 17 00:00:00 2001 From: Dylan Hung Date: Thu, 9 Dec 2021 10:12:24 +0800 Subject: [PATCH] net: ftgmac100: Add DM_MDIO support Add support for DM_MDIO to connect to PHY. For the systems that have a stand-alone MDIO hardware block, enable CONFIG_DM_MDIO to use driver model for MDIO devices. Signed-off-by: Dylan Hung Reviewed-by: Ramon Fried --- drivers/net/ftgmac100.c | 20 +++++++++++++++----- 1 file changed, 15 insertions(+), 5 deletions(-) diff --git a/drivers/net/ftgmac100.c b/drivers/net/ftgmac100.c index 0687230b4b..b6e9526c3b 100644 --- a/drivers/net/ftgmac100.c +++ b/drivers/net/ftgmac100.c @@ -220,7 +220,11 @@ static int ftgmac100_phy_init(struct udevice *dev) struct phy_device *phydev; int ret; - phydev = phy_connect(priv->bus, priv->phy_addr, dev, priv->phy_mode); + if (IS_ENABLED(CONFIG_DM_MDIO)) + phydev = dm_eth_phy_connect(dev); + else + phydev = phy_connect(priv->bus, priv->phy_addr, dev, priv->phy_mode); + if (!phydev) return -ENODEV; @@ -589,10 +593,16 @@ static int ftgmac100_probe(struct udevice *dev) if (ret) goto out; - ret = ftgmac100_mdio_init(dev); - if (ret) { - dev_err(dev, "Failed to initialize mdiobus: %d\n", ret); - goto out; + /* + * If DM MDIO is enabled, the MDIO bus will be initialized later in + * dm_eth_phy_connect + */ + if (!IS_ENABLED(CONFIG_DM_MDIO)) { + ret = ftgmac100_mdio_init(dev); + if (ret) { + dev_err(dev, "Failed to initialize mdiobus: %d\n", ret); + goto out; + } } ret = ftgmac100_phy_init(dev); -- 2.39.5