From 90ab7fafb65f13cff94c8260f96b73fed3ff8a21 Mon Sep 17 00:00:00 2001 From: Ashok Reddy Soma Date: Wed, 23 Feb 2022 15:36:05 +0100 Subject: [PATCH] mmc: zynq_sdhci: Add support for dynamic configuration Add support for dynamic configuration which will takes care of configuring the SD secure space configuration registers using firmware APIs, performing SD reset assert and deassert. High level sequence: - Check for the PM dynamic configuration support, if no error proceed with SD dynamic configurations(next steps) otherwise skip the dynamic configuration. - Put the SD Controller in reset. - Configure SD Fixed configurations. - Configure the SD Slot Type. - Configure the BASE_CLOCK. - Configure the 8-bit support. - Bring the SD Controller out of reset. In the above steps, apart from the Fixed configurations, remaining all configurations are dynamic and they will be read from devicetree. And also remove hardcoded secure register writes, as dynamic sd config support is added. Signed-off-by: Ashok Reddy Soma Signed-off-by: Michal Simek Link: https://lore.kernel.org/r/030a3ec041ff3efebd574b4d2b477ad85f12cbce.1645626962.git.michal.simek@xilinx.com --- drivers/mmc/zynq_sdhci.c | 101 ++++++++++++++++++++++++++++++++++++++- 1 file changed, 99 insertions(+), 2 deletions(-) diff --git a/drivers/mmc/zynq_sdhci.c b/drivers/mmc/zynq_sdhci.c index 33d00b06c7..d96f5d543f 100644 --- a/drivers/mmc/zynq_sdhci.c +++ b/drivers/mmc/zynq_sdhci.c @@ -12,9 +12,12 @@ #include #include "mmc_private.h" #include +#include #include #include #include +#include +#include #include #include #include @@ -61,6 +64,7 @@ struct arasan_sdhci_priv { u8 deviceid; u8 bank; u8 no_1p8; + struct reset_ctl_bulk resets; }; /* For Versal platforms zynqmp_mmio_write() won't be available */ @@ -243,7 +247,7 @@ static int arasan_sdhci_execute_tuning(struct mmc *mmc, u8 opcode) char tuning_loop_counter = SDHCI_TUNING_LOOP_COUNT; u8 node_id = priv->deviceid ? NODE_SD_1 : NODE_SD_0; - debug("%s\n", __func__); + dev_dbg(mmc->dev, "%s\n", __func__); host = priv->host; @@ -703,6 +707,87 @@ static const struct sdhci_ops arasan_ops = { }; #endif +#if defined(CONFIG_ARCH_ZYNQMP) +static int sdhci_zynqmp_set_dynamic_config(struct arasan_sdhci_priv *priv, + struct udevice *dev) +{ + int ret; + u32 node_id = priv->deviceid ? NODE_SD_1 : NODE_SD_0; + struct clk clk; + unsigned long clock, mhz; + + ret = xilinx_pm_request(PM_REQUEST_NODE, node_id, ZYNQMP_PM_CAPABILITY_ACCESS, + ZYNQMP_PM_MAX_QOS, ZYNQMP_PM_REQUEST_ACK_NO, NULL); + if (ret) { + dev_err(dev, "Request node failed for %d\n", node_id); + return ret; + } + + ret = reset_get_bulk(dev, &priv->resets); + if (ret == -ENOTSUPP || ret == -ENOENT) { + dev_err(dev, "Reset not found\n"); + return 0; + } else if (ret) { + dev_err(dev, "Reset failed\n"); + return ret; + } + + ret = reset_assert_bulk(&priv->resets); + if (ret) { + dev_err(dev, "Reset assert failed\n"); + return ret; + } + + ret = zynqmp_pm_set_sd_config(node_id, SD_CONFIG_FIXED, 0); + if (ret) { + dev_err(dev, "SD_CONFIG_FIXED failed\n"); + return ret; + } + + ret = zynqmp_pm_set_sd_config(node_id, SD_CONFIG_EMMC_SEL, + dev_read_bool(dev, "non-removable")); + if (ret) { + dev_err(dev, "SD_CONFIG_EMMC_SEL failed\n"); + return ret; + } + + ret = clk_get_by_index(dev, 0, &clk); + if (ret < 0) { + dev_err(dev, "failed to get clock\n"); + return ret; + } + + clock = clk_get_rate(&clk); + if (IS_ERR_VALUE(clock)) { + dev_err(dev, "failed to get rate\n"); + return clock; + } + + mhz = DIV64_U64_ROUND_UP(clock, 1000000); + + ret = zynqmp_pm_set_sd_config(node_id, SD_CONFIG_BASECLK, mhz); + if (ret) { + dev_err(dev, "SD_CONFIG_BASECLK failed\n"); + return ret; + } + + ret = zynqmp_pm_set_sd_config(node_id, SD_CONFIG_8BIT, + (dev_read_u32_default(dev, "bus-width", 1) == 8)); + if (ret) { + dev_err(dev, "SD_CONFIG_8BIT failed\n"); + return ret; + } + + ret = reset_deassert_bulk(&priv->resets); + if (ret) { + dev_err(dev, "Reset release failed\n"); + return ret; + } + + return 0; +} +#endif + static int arasan_sdhci_probe(struct udevice *dev) { struct arasan_sdhci_plat *plat = dev_get_plat(dev); @@ -715,6 +800,18 @@ static int arasan_sdhci_probe(struct udevice *dev) host = priv->host; +#if defined(CONFIG_ARCH_ZYNQMP) + if (device_is_compatible(dev, "xlnx,zynqmp-8.9a")) { + ret = zynqmp_pm_is_function_supported(PM_IOCTL, + IOCTL_SET_SD_CONFIG); + if (!ret) { + ret = sdhci_zynqmp_set_dynamic_config(priv, dev); + if (ret) + return ret; + } + } +#endif + ret = clk_get_by_index(dev, 0, &clk); if (ret < 0) { dev_err(dev, "failed to get clock\n"); @@ -727,7 +824,7 @@ static int arasan_sdhci_probe(struct udevice *dev) return clock; } - debug("%s: CLK %ld\n", __func__, clock); + dev_dbg(dev, "%s: CLK %ld\n", __func__, clock); ret = clk_enable(&clk); if (ret) { -- 2.39.5