From 0714580346cc0b3999d62e0949b17561a965a24b Mon Sep 17 00:00:00 2001 From: Tero Kristo Date: Fri, 11 Jun 2021 11:45:20 +0300 Subject: [PATCH] arm: mach-k3: do board config for PM only if supported If the raw PM support is built in, we are operating in the split firmware approach mode where PM support is not available. In this case, skip the board config for this. Signed-off-by: Tero Kristo Signed-off-by: Tero Kristo --- arch/arm/mach-k3/sysfw-loader.c | 2 ++ 1 file changed, 2 insertions(+) diff --git a/arch/arm/mach-k3/sysfw-loader.c b/arch/arm/mach-k3/sysfw-loader.c index 0bacfc4d07..41449db89d 100644 --- a/arch/arm/mach-k3/sysfw-loader.c +++ b/arch/arm/mach-k3/sysfw-loader.c @@ -159,11 +159,13 @@ static void k3_sysfw_configure_using_fit(void *fit, ret); /* Apply power/clock (PM) specific configuration to SYSFW */ +#if !CONFIG_IS_ENABLED(K3_DM_FW) ret = board_ops->board_config_pm(ti_sci, (u64)(u32)cfg_fragment_addr, (u32)cfg_fragment_size); if (ret) panic("Failed to set board PM configuration (%d)\n", ret); +#endif /* Extract resource management (RM) specific configuration from FIT */ ret = fit_get_data_by_name(fit, images, SYSFW_CFG_RM, -- 2.39.5