From: Pali Rohár Date: Fri, 24 Sep 2021 20:59:19 +0000 (+0200) Subject: arm: mvebu: a38x: serdes: Don't overwrite PCI device ID X-Git-Url: http://git.dujemihanovic.xyz/img/sics.gif?a=commitdiff_plain;h=db5ea818ce8fed95931169bbc487a64e959552d5;p=u-boot.git arm: mvebu: a38x: serdes: Don't overwrite PCI device ID PCI device ID is part of the PCIe controller SoC / revision. For Root Complex mode (which is the default and the only mode supported currently by U-Boot and Linux kernel), it is PCI device ID of PCIe Root Port device. If there is some issue with this device ID, it should be set / updated by PCIe controller driver (pci_mvebu.c), as this register resides in address space of the controller. It shouldn't be done in SerDes initialization code. In the worst case (a specific board for example) it could be done via U-Boot's weak function board_pex_config(). But it should not be overwritten globally for all A38x devices. Signed-off-by: Pali Rohár Reviewed-by: Marek Behún Reviewed-by: Stefan Roese --- diff --git a/arch/arm/mach-mvebu/serdes/a38x/ctrl_pex.c b/arch/arm/mach-mvebu/serdes/a38x/ctrl_pex.c index 7c18df8113..a7e45a5550 100644 --- a/arch/arm/mach-mvebu/serdes/a38x/ctrl_pex.c +++ b/arch/arm/mach-mvebu/serdes/a38x/ctrl_pex.c @@ -186,33 +186,6 @@ int hws_pex_config(const struct serdes_map *serdes_map, u8 count) (": Link upgraded to Gen2 based on client capabilities\n"); } - /* Update pex DEVICE ID */ - ctrl_mode = sys_env_model_get(); - - for (idx = 0; idx < count; idx++) { - serdes_type = serdes_map[idx].serdes_type; - /* configuration for PEX only */ - if ((serdes_type != PEX0) && (serdes_type != PEX1) && - (serdes_type != PEX2) && (serdes_type != PEX3)) - continue; - - if ((serdes_type != PEX0) && - ((serdes_map[idx].serdes_mode == PEX_ROOT_COMPLEX_X4) || - (serdes_map[idx].serdes_mode == PEX_END_POINT_X4))) { - /* for PEX by4 - relevant for the first port only */ - continue; - } - - pex_idx = serdes_type - PEX0; - dev_id = reg_read(PEX_CFG_DIRECT_ACCESS - (pex_idx, PEX_DEVICE_AND_VENDOR_ID)); - dev_id &= 0xffff; - dev_id |= ((ctrl_mode << 16) & 0xffff0000); - reg_write(PEX_CFG_DIRECT_ACCESS - (pex_idx, PEX_DEVICE_AND_VENDOR_ID), dev_id); - } - DEBUG_INIT_FULL_C("Update PEX Device ID ", ctrl_mode, 4); - return MV_OK; }