From: Nishanth Menon Date: Tue, 26 Mar 2013 05:20:50 +0000 (+0000) Subject: twl4030: make twl4030_i2c_read_u8 prototype consistent X-Git-Url: http://git.dujemihanovic.xyz/img/sics.gif?a=commitdiff_plain;h=b29c2f0c142fdb8ef50deae1cc7c4338952fba6c;p=u-boot.git twl4030: make twl4030_i2c_read_u8 prototype consistent u-boot standard i2c read prototype is i2c_read(addr, reg, 1, &buf, 1) twl4030_i2c_read_u8(u8 addr, u8 *val, u8 reg) does not provide consistency, so switch the prototype to be consistent with rest of u-boot i2c operations: twl4030_i2c_read_u8(u8 addr, u8 reg, u8 *val) Signed-off-by: Nishanth Menon --- diff --git a/board/cm_t35/cm_t35.c b/board/cm_t35/cm_t35.c index 87d73546a2..85286809d3 100644 --- a/board/cm_t35/cm_t35.c +++ b/board/cm_t35/cm_t35.c @@ -448,7 +448,7 @@ int board_mmc_getcd(struct mmc *mmc) { u8 val; - if (twl4030_i2c_read_u8(TWL4030_CHIP_GPIO, &val, TWL4030_BASEADD_GPIO)) + if (twl4030_i2c_read_u8(TWL4030_CHIP_GPIO, TWL4030_BASEADD_GPIO, &val)) return -1; return !(val & 1); @@ -597,7 +597,7 @@ int ehci_hcd_init(int index, struct ehci_hccr **hccr, struct ehci_hcor **hcor) udelay(1000); offset = TWL4030_BASEADD_GPIO + TWL4030_GPIO_GPIODATADIR1; - twl4030_i2c_read_u8(TWL4030_CHIP_GPIO, &val, offset); + twl4030_i2c_read_u8(TWL4030_CHIP_GPIO, offset, &val); /* Set GPIO6 and GPIO7 of TPS65930 as output */ val |= 0xC0; twl4030_i2c_write_u8(TWL4030_CHIP_GPIO, offset, val); diff --git a/board/nokia/rx51/rx51.c b/board/nokia/rx51/rx51.c index 860d52da3f..42bf8b669d 100644 --- a/board/nokia/rx51/rx51.c +++ b/board/nokia/rx51/rx51.c @@ -406,8 +406,8 @@ int misc_init_r(void) TWL4030_PM_RECEIVER_DEV_GRP_P1); /* store I2C access state */ - twl4030_i2c_read_u8(TWL4030_CHIP_PM_MASTER, &state, - TWL4030_PM_MASTER_PB_CFG); + twl4030_i2c_read_u8(TWL4030_CHIP_PM_MASTER, TWL4030_PM_MASTER_PB_CFG, + &state); /* enable I2C access to powerbus (needed for twl4030 regulator) */ twl4030_i2c_write_u8(TWL4030_CHIP_PM_MASTER, TWL4030_PM_MASTER_PB_CFG, @@ -475,8 +475,8 @@ void hw_watchdog_reset(void) return; /* read actual watchdog timeout */ - twl4030_i2c_read_u8(TWL4030_CHIP_PM_RECEIVER, &timeout, - TWL4030_PM_RECEIVER_WATCHDOG_CFG); + twl4030_i2c_read_u8(TWL4030_CHIP_PM_RECEIVER, + TWL4030_PM_RECEIVER_WATCHDOG_CFG, &timeout); /* timeout 0 means watchdog is disabled */ /* reset watchdog timeout to 31s (maximum) */ @@ -531,8 +531,8 @@ int rx51_kp_init(void) { int ret = 0; u8 ctrl; - ret = twl4030_i2c_read_u8(TWL4030_CHIP_KEYPAD, &ctrl, - TWL4030_KEYPAD_KEYP_CTRL_REG); + ret = twl4030_i2c_read_u8(TWL4030_CHIP_KEYPAD, + TWL4030_KEYPAD_KEYP_CTRL_REG, &ctrl); if (ret) return ret; @@ -615,8 +615,8 @@ int rx51_kp_tstc(void) for (i = 0; i < 2; i++) { /* check interrupt register for events */ - twl4030_i2c_read_u8(TWL4030_CHIP_KEYPAD, &intr, - TWL4030_KEYPAD_KEYP_ISR1+(2*i)); + twl4030_i2c_read_u8(TWL4030_CHIP_KEYPAD, + TWL4030_KEYPAD_KEYP_ISR1 + (2 * i), &intr); /* no event */ if (!(intr&1)) diff --git a/drivers/power/twl4030.c b/drivers/power/twl4030.c index 2bf94b134c..6610f787d0 100644 --- a/drivers/power/twl4030.c +++ b/drivers/power/twl4030.c @@ -45,8 +45,8 @@ void twl4030_power_reset_init(void) { u8 val = 0; - if (twl4030_i2c_read_u8(TWL4030_CHIP_PM_MASTER, &val, - TWL4030_PM_MASTER_P1_SW_EVENTS)) { + if (twl4030_i2c_read_u8(TWL4030_CHIP_PM_MASTER, + TWL4030_PM_MASTER_P1_SW_EVENTS, &val)) { printf("Error:TWL4030: failed to read the power register\n"); printf("Could not initialize hardware reset\n"); } else { diff --git a/drivers/usb/phy/twl4030.c b/drivers/usb/phy/twl4030.c index f41cc07fe7..74f1dccbd4 100644 --- a/drivers/usb/phy/twl4030.c +++ b/drivers/usb/phy/twl4030.c @@ -66,7 +66,7 @@ static int twl4030_usb_read(u8 address) u8 data; int ret; - ret = twl4030_i2c_read_u8(TWL4030_CHIP_USB, &data, address); + ret = twl4030_i2c_read_u8(TWL4030_CHIP_USB, address, &data); if (ret == 0) ret = data; else diff --git a/include/twl4030.h b/include/twl4030.h index aca695d5bb..569ad2773f 100644 --- a/include/twl4030.h +++ b/include/twl4030.h @@ -643,7 +643,7 @@ static inline int twl4030_i2c_write_u8(u8 chip_no, u8 reg, u8 val) return i2c_write(chip_no, reg, 1, &val, 1); } -static inline int twl4030_i2c_read_u8(u8 chip_no, u8 *val, u8 reg) +static inline int twl4030_i2c_read_u8(u8 chip_no, u8 reg, u8 *val) { return i2c_read(chip_no, reg, 1, val, 1); }