From: Gong Qianyu Date: Fri, 18 Dec 2015 09:38:01 +0000 (+0800) Subject: i2c: mxc: add a condition in case the parameter is NULL X-Git-Url: http://git.dujemihanovic.xyz/img/sics.gif?a=commitdiff_plain;h=aee3fddb677d86a131d9ac7bac2251f9a6ab2975;p=u-boot.git i2c: mxc: add a condition in case the parameter is NULL This could avoid executing the code that only applies to i.MX platforms. The bus_i2c_init() is called before relocation and will assgin value to a static variable. If U-Boot is then still running in a flash device, it's theoretically not allowed to write data to flash without an erasing operation. For i.MX platforms, the U-Boot is always running in DDR. Actually it causes asynchronous error when the ARM64 system error report is enabled and the flash write protect is set. Signed-off-by: Gong Qianyu Reviewed-by: Heiko Schocher --- diff --git a/drivers/i2c/mxc_i2c.c b/drivers/i2c/mxc_i2c.c index fa4c82f1a2..b2d15c9b6a 100644 --- a/drivers/i2c/mxc_i2c.c +++ b/drivers/i2c/mxc_i2c.c @@ -581,8 +581,16 @@ void bus_i2c_init(int index, int speed, int unused, return; } - mxc_i2c_buses[index].idle_bus_fn = idle_bus_fn; - mxc_i2c_buses[index].idle_bus_data = idle_bus_data; + /* + * Warning: Be careful to allow the assignment to a static + * variable here. This function could be called while U-Boot is + * still running in flash memory. So such assignment is equal + * to write data to flash without erasing. + */ + if (idle_bus_fn) + mxc_i2c_buses[index].idle_bus_fn = idle_bus_fn; + if (idle_bus_data) + mxc_i2c_buses[index].idle_bus_data = idle_bus_data; ret = enable_i2c_clk(1, index); if (ret < 0) {