From: Tim Harvey <tharvey@gateworks.com>
Date: Fri, 31 May 2024 15:36:33 +0000 (-0700)
Subject: mmc: use an enumerated type to represent PARTITION_CONFIG fields
X-Git-Url: http://git.dujemihanovic.xyz/img/sics.gif?a=commitdiff_plain;h=8746aa0f5da740c593cef95b7c28386716f128d6;p=u-boot.git

mmc: use an enumerated type to represent PARTITION_CONFIG fields

Modern eMMC v4+ devices have multiple hardware partitions per the JEDEC
specification described as:
  Boot Area Partition 1
  Boot Area Partition 2
  RPMB Partition
  General Purpose Partition 1
  General Purpose Partition 2
  General Purpose Partition 3
  General Purpose Partition 4
  User Data Area

These are referenced by fields in the PARTITION_CONFIG register
(Extended CSD Register 179) which is defined as:
bit 7: reserved
bit 6: BOOT_ACK
  0x0: No boot acknowledge sent (default
  0x1: Boot acknowledge sent during boot operation Bit
bit 5:3: BOOT_PARTITION_ENABLE
  0x0: Device not boot enabled (default)
  0x1: Boot Area partition 1 enabled for boot
  0x2: Boot Area partition 2 enabled for boot
  0x3-0x6: Reserved
  0x7: User area enabled for boot
bit 2:0 PARTITION_ACCESS
  0x0: No access to boot partition (default)
  0x1: Boot Area partition 1
  0x2: Boot Area partition 2
  0x3: Replay Protected Memory Block (RPMB)
  0x4: Access to General Purpose partition 1
  0x5: Access to General Purpose partition 2
  0x6: Access to General Purpose partition 3
  0x7: Access to General Purpose partition 4

Note that setting PARTITION_ACCESS to 0x0 results in selecting the User
Data Area partition.

You can see above that the two fields BOOT_PARTITION_ENABLE and
PARTITION_ACCESS do not use the same enumerated values.

U-Boot uses a set of macros to access fields of the PARTITION_CONFIG
register:

There are various places in U-Boot where the BOOT_PARTITION_ENABLE field
is accessed via EXT_CSD_EXTRACT_PARTITION_ACCESS and converted to a
hardware partition consistent with the definition of the
PARTITION_ACCESS field which is also the value used to specify the
hardware partition of the various mmc_switch incarnations.

To add some sanity to the distinction between BOOT_PARTITION_ENABLE
(used to specify the active device on power-cycle) and PARTITION_ACCESS
(used to switch between hardware partitions) create two enumerated types
and use them wherever struct mmc * part_config is used or the above
macros are used.

This represents no code changes.

Signed-off-by: Tim Harvey <tharvey@gateworks.com>
---

diff --git a/arch/arm/mach-imx/image-container.c b/arch/arm/mach-imx/image-container.c
index 35da0ae042..bcd40889f0 100644
--- a/arch/arm/mach-imx/image-container.c
+++ b/arch/arm/mach-imx/image-container.c
@@ -205,7 +205,7 @@ static unsigned long get_boot_device_offset(void *dev, int dev_type)
 		} else {
 			u8 part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config);
 
-			if (part == 1 || part == 2) {
+			if (part == EMMC_BOOT_PART_BOOT1 || part == EMMC_BOOT_PART_BOOT2) {
 				if (is_imx8qxp() && is_soc_rev(CHIP_REV_B))
 					offset = CONTAINER_HDR_MMCSD_OFFSET;
 				else
@@ -294,15 +294,15 @@ int spl_mmc_emmc_boot_partition(struct mmc *mmc)
 	int part;
 
 	part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config);
-	if (part == 1 || part == 2) {
+	if (part == EMMC_BOOT_PART_BOOT1 || part == EMMC_BOOT_PART_BOOT2) {
 		unsigned long sec_set_off = 0;
 		bool sec_boot = false;
 
 		sec_boot = check_secondary_cnt_set(&sec_set_off);
 		if (sec_boot)
-			part = (part == 1) ? 2 : 1;
-	} else if (part == 7) {
-		part = 0;
+			part = (part == EMMC_BOOT_PART_BOOT1) ? EMMC_HWPART_BOOT2 : EMMC_HWPART_BOOT1;
+	} else if (part == EMMC_BOOT_PART_USER) {
+		part = EMMC_HWPART_DEFAULT;
 	}
 
 	return part;
diff --git a/arch/arm/mach-sunxi/board.c b/arch/arm/mach-sunxi/board.c
index 0140b07d32..860e7058b6 100644
--- a/arch/arm/mach-sunxi/board.c
+++ b/arch/arm/mach-sunxi/board.c
@@ -396,7 +396,7 @@ static bool sunxi_valid_emmc_boot(struct mmc *mmc)
 		return false;
 
 	/* Partition 0 is the user data partition, bootpart must be 1 or 2. */
-	if (bootpart != 1 && bootpart != 2)
+	if (bootpart != EMMC_BOOT_PART_BOOT1 && bootpart != EMMC_BOOT_PART_BOOT2)
 		return false;
 
 	/* Failure to switch to the boot partition is fatal. */
diff --git a/board/gateworks/venice/spl.c b/board/gateworks/venice/spl.c
index b0a315ba95..05911ce9dd 100644
--- a/board/gateworks/venice/spl.c
+++ b/board/gateworks/venice/spl.c
@@ -350,8 +350,8 @@ unsigned long board_spl_mmc_get_uboot_raw_sector(struct mmc *mmc, unsigned long
 {
 	if (!IS_SD(mmc)) {
 		switch (EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config)) {
-		case 1:
-		case 2:
+		case EMMC_BOOT_PART_BOOT1:
+		case EMMC_BOOT_PART_BOOT2:
 			if (IS_ENABLED(CONFIG_IMX8MN) || IS_ENABLED(CONFIG_IMX8MP))
 				raw_sect -= 32 * 2;
 			break;
diff --git a/board/gateworks/venice/venice.c b/board/gateworks/venice/venice.c
index 5b105d7659..44ed4e4598 100644
--- a/board/gateworks/venice/venice.c
+++ b/board/gateworks/venice/venice.c
@@ -173,20 +173,20 @@ int board_late_init(void)
 			int bootpart;
 
 			switch (EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config)) {
-			case 1: /* boot0 */
-				bootpart = 1;
+			case EMMC_BOOT_PART_BOOT1:
+				bootpart = EMMC_HWPART_BOOT1;
 				break;
-			case 2: /* boot1 */
-				bootpart = 2;
+			case EMMC_BOOT_PART_BOOT2:
+				bootpart = EMMC_HWPART_BOOT2;
 				break;
-			case 7: /* user */
+			case EMMC_BOOT_PART_USER:
 			default:
-				bootpart = 0;
+				bootpart = EMMC_HWPART_DEFAULT;
 				break;
 			}
 			/* IMX8MP/IMX8MN BOOTROM v2 uses offset=0 for boot parts */
 			if ((IS_ENABLED(CONFIG_IMX8MN) || IS_ENABLED(CONFIG_IMX8MP)) &&
-			    (bootpart == 1 || bootpart == 2))
+			    (bootpart == EMMC_BOOT_PART_BOOT1 || bootpart == EMMC_BOOT_PART_BOOT2))
 				bootblk = 0;
 			env_set_hex("bootpart", bootpart);
 			env_set_hex("bootblk", bootblk);
@@ -217,10 +217,10 @@ uint mmc_get_env_part(struct mmc *mmc)
 {
 	if (!IS_SD(mmc)) {
 		switch (EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config)) {
-		case 1:
-			return 1;
-		case 2:
-			return 2;
+		case EMMC_BOOT_PART_BOOT1:
+			return EMMC_HWPART_BOOT1;
+		case EMMC_BOOT_PART_BOOT2:
+			return EMMC_HWPART_BOOT2;
 		}
 	}
 
diff --git a/board/purism/librem5/librem5.c b/board/purism/librem5/librem5.c
index d0249e71f0..3f1a8e385d 100644
--- a/board/purism/librem5/librem5.c
+++ b/board/purism/librem5/librem5.c
@@ -43,8 +43,8 @@ uint board_mmc_get_env_part(struct mmc *mmc)
 {
 	uint part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config);
 
-	if (part == 7)
-		part = 0;
+	if (part == EMMC_BOOT_PART_USER)
+		part = EMMC_HWPART_DEFAULT;
 	return part;
 }
 #endif
diff --git a/board/storopack/smegw01/smegw01.c b/board/storopack/smegw01/smegw01.c
index 345191b31c..d1f474bc7a 100644
--- a/board/storopack/smegw01/smegw01.c
+++ b/board/storopack/smegw01/smegw01.c
@@ -106,8 +106,8 @@ uint mmc_get_env_part(struct mmc *mmc)
 {
 	uint part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config);
 
-	if (part == 7)
-		part = 0;
+	if (part == EMMC_BOOT_PART_USER)
+		part = EMMC_HWPART_DEFAULT;
 	return part;
 }
 
diff --git a/cmd/mvebu/bubt.c b/cmd/mvebu/bubt.c
index 744b1c20aa..1e3f5bf7ad 100644
--- a/cmd/mvebu/bubt.c
+++ b/cmd/mvebu/bubt.c
@@ -224,8 +224,8 @@ static int mmc_burn_image(size_t image_size)
 #endif
 
 	part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config);
-	if (part == 7)
-		part = 0;
+	if (part == EMMC_BOOT_PART_USER)
+		part = EMMC_HWPART_DEFAULT;
 
 #ifdef CONFIG_BLK
 	err = blk_dselect_hwpart(blk_desc, part);
diff --git a/common/spl/spl_mmc.c b/common/spl/spl_mmc.c
index 3d032bb27c..fd5154dad7 100644
--- a/common/spl/spl_mmc.c
+++ b/common/spl/spl_mmc.c
@@ -320,8 +320,8 @@ int default_spl_mmc_emmc_boot_partition(struct mmc *mmc)
 	 * which is the first physical partition (0).
 	 */
 	part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config);
-	if (part == 7)
-		part = 0;
+	if (part == EMMC_BOOT_PART_USER)
+		part = EMMC_HWPART_DEFAULT;
 #endif
 	return part;
 }
diff --git a/include/mmc.h b/include/mmc.h
index 4b8327f1f9..0f3f1ed6aa 100644
--- a/include/mmc.h
+++ b/include/mmc.h
@@ -381,6 +381,26 @@ enum mmc_voltage {
 #define MMC_TIMING_MMC_HS200	9
 #define MMC_TIMING_MMC_HS400	10
 
+/* emmc PARTITION_CONFIG BOOT_PARTITION_ENABLE values */
+enum emmc_boot_part {
+	EMMC_BOOT_PART_DEFAULT = 0,
+	EMMC_BOOT_PART_BOOT1 = 1,
+	EMMC_BOOT_PART_BOOT2 = 2,
+	EMMC_BOOT_PART_USER = 7,
+};
+
+/* emmc PARTITION_CONFIG ACCESS_ENABLE values */
+enum emmc_hwpart {
+	EMMC_HWPART_DEFAULT = 0, /* user */
+	EMMC_HWPART_BOOT1 = 1,
+	EMMC_HWPART_BOOT2 = 2,
+	EMMC_HWPART_RPMB = 3,
+	EMMC_HWPART_GP1 = 4,
+	EMMC_HWPART_GP2 = 5,
+	EMMC_HWPART_GP3 = 6,
+	EMMC_HWPART_GP4 = 7,
+};
+
 /* Driver model support */
 
 /**