From: Heinrich Schuchardt Date: Sat, 2 Apr 2022 05:16:56 +0000 (+0200) Subject: doc: correct bootefi.rst X-Git-Url: http://git.dujemihanovic.xyz/img/sics.gif?a=commitdiff_plain;h=56bc239db201e00e9885223cf03333b5d369e1be;p=u-boot.git doc: correct bootefi.rst * add link to booti man-page * correct link description for efidebug command * correct punctuation Signed-off-by: Heinrich Schuchardt --- diff --git a/doc/usage/cmd/bootefi.rst b/doc/usage/cmd/bootefi.rst index 282f22aac9..31279fc0cb 100644 --- a/doc/usage/cmd/bootefi.rst +++ b/doc/usage/cmd/bootefi.rst @@ -24,7 +24,7 @@ The *bootefi* command is used to launch a UEFI binary which can be either of * UEFI run-time services driver An operating system requires a hardware description which can either be -presented as ACPI table (CONFIG\_GENERATE\_ACPI\_TABLE=y) or as device-tree +presented as ACPI table (CONFIG\_GENERATE\_ACPI\_TABLE=y) or as device-tree. The load address of the device-tree may be provided as parameter *fdt\_addr*. If this address is not specified, the bootefi command will try to fall back in sequence to: @@ -123,6 +123,7 @@ Configuration ------------- To use the *bootefi* command you must specify CONFIG\_CMD\_BOOTEFI=y. +The *bootefi bootmgr* sub-command requries CMD\_BOOTEFI\_BOOTMGR=y. The *bootefi hello* sub-command requries CMD\_BOOTEFI\_HELLO=y. The *bootefi selftest* sub-command depends on CMD\_BOOTEFI\_SELFTEST=y. @@ -130,6 +131,6 @@ See also -------- * *bootm* for launching UEFI binaries packed in FIT images -* *booti*, *bootm*, *bootz* for launching a Linux kernel without using the - UEFI sub-system -* *efidebug* for setting UEFI boot variables +* :doc:`booti`, *bootm*, *bootz* for launching a Linux kernel without + using the UEFI sub-system +* *efidebug* for setting UEFI boot variables and boot options