From: Miquel Raynal Date: Wed, 28 Feb 2018 19:51:43 +0000 (+0100) Subject: spl: fix binman_sym output check X-Git-Url: http://git.dujemihanovic.xyz/img/sics.gif?a=commitdiff_plain;h=55fe0e2b54173ebdc2aa87c329750c2a70e84fb2;p=u-boot.git spl: fix binman_sym output check A previous commit introduced the use of binman in the SPL. After the binman_sym call over the 'pos' symbol, the output value is checked against BINMAN_SYM_MISSING (-1UL). According to the documentation (tools/binman/README), when it comes to the 'pos' attribute: pos: This sets the position of an entry within the image. The first byte of the image is normally at position 0. If 'pos' is not provided, binman sets it to the end of the previous region, or the start of the image's entry area (normally 0) if there is no previous region. So instead of checking if the return value is BINMAN_SYM_MISSING, we should also check if the value is not null. The failure happens when using both the SPL file and the U-Boot file independently instead of the concatenated file (SPL + padding + U-Boot). This is because the U-Boot binary file alone does not have the U-Boot header while it is present in the concatenation file. Not having the header forces the SPL to discover where it should load U-Boot. The binman_sym call is supposed to do that but fails. Because of the wrong check, the destination address was set to 0 while it should have been somewhere in RAM. This, obviously, stalls the board. Fixes: 8bee2d251afb ("binman: Add binman symbol support to SPL") Reviewed-by: Simon Glass Signed-off-by: Miquel Raynal Signed-off-by: Maxime Ripard --- diff --git a/common/spl/spl.c b/common/spl/spl.c index b1ce56d0d0..61d3071324 100644 --- a/common/spl/spl.c +++ b/common/spl/spl.c @@ -127,8 +127,14 @@ void spl_set_header_raw_uboot(struct spl_image_info *spl_image) ulong u_boot_pos = binman_sym(ulong, u_boot_any, pos); spl_image->size = CONFIG_SYS_MONITOR_LEN; - if (u_boot_pos != BINMAN_SYM_MISSING) { - /* biman does not support separate entry addresses at present */ + + /* + * Binman error cases: address of the end of the previous region or the + * start of the image's entry area (usually 0) if there is no previous + * region. + */ + if (u_boot_pos && u_boot_pos != BINMAN_SYM_MISSING) { + /* Binman does not support separated entry addresses */ spl_image->entry_point = u_boot_pos; spl_image->load_addr = u_boot_pos; } else {