From: Peng Fan Date: Fri, 19 Mar 2021 07:57:04 +0000 (+0800) Subject: imx8mp_evk: Increase VDD_ARM to 0.95v Overdrive voltage X-Git-Url: http://git.dujemihanovic.xyz/img/sics.gif?a=commitdiff_plain;h=41037bc47c293dc6cdf6c7f03ffefc35b4217bba;p=u-boot.git imx8mp_evk: Increase VDD_ARM to 0.95v Overdrive voltage There is a frequency/timing limitation for SOC and ARM, if SOC is OD voltage/OD freq, then ARM can't run at ND voltage/1.2Ghz, it may have timing risk from SOC to ARM. Current VDD_SOC is set to 0.95v OD voltage in SPL, and kernel will increase bus clocks to OD frequency before it increases ARM voltage. So to conform to the limitation, we'd better increases VDD_ARM to OD voltage in SPL. Signed-off-by: Ye Li Signed-off-by: Peng Fan --- diff --git a/board/freescale/imx8mp_evk/spl.c b/board/freescale/imx8mp_evk/spl.c index ef14cfc227..6ccf5ac8fa 100644 --- a/board/freescale/imx8mp_evk/spl.c +++ b/board/freescale/imx8mp_evk/spl.c @@ -35,6 +35,16 @@ void spl_dram_init(void) void spl_board_init(void) { + /* + * Set GIC clock to 500Mhz for OD VDD_SOC. Kernel driver does + * not allow to change it. Should set the clock after PMIC + * setting done. Default is 400Mhz (system_pll1_800m with div = 2) + * set by ROM for ND VDD_SOC + */ + clock_enable(CCGR_GIC, 0); + clock_set_target_val(GIC_CLK_ROOT, CLK_ROOT_ON | CLK_ROOT_SOURCE_SEL(5)); + clock_enable(CCGR_GIC, 1); + puts("Normal Boot\n"); } @@ -84,6 +94,10 @@ int power_init_board(void) pmic_reg_write(p, PCA9450_BUCK1OUT_DVS1, 0x14); pmic_reg_write(p, PCA9450_BUCK1CTRL, 0x59); + /* Kernel uses OD/OD freq for SOC */ + /* To avoid timing risk from SOC to ARM,increase VDD_ARM to OD voltage 0.95v */ + pmic_reg_write(p, PCA9450_BUCK2OUT_DVS0, 0x1C); + /* set WDOG_B_CFG to cold reset */ pmic_reg_write(p, PCA9450_RESET_CTRL, 0xA1);