From: Peter Korsgaard Date: Wed, 17 Oct 2012 09:20:46 +0000 (+0000) Subject: omap3_spi: introduce CONFIG_OMAP3_SPI_D0_D1_SWAPPED X-Git-Url: http://git.dujemihanovic.xyz/img/sics.gif?a=commitdiff_plain;h=22cbeed454087ffa6ae6e56880bfff125497619b;p=u-boot.git omap3_spi: introduce CONFIG_OMAP3_SPI_D0_D1_SWAPPED D0/D1 Swapped or not is a board property, not anything specific to the am33xx SoC, so add a custom define for it. At the same time correct the bit handling for the swapped mode (DPE0 should be cleared and SI/DPE1 set). Signed-off-by: Peter Korsgaard --- diff --git a/drivers/spi/omap3_spi.c b/drivers/spi/omap3_spi.c index e40a632caa..6791a7e0ec 100644 --- a/drivers/spi/omap3_spi.c +++ b/drivers/spi/omap3_spi.c @@ -173,14 +173,13 @@ int spi_claim_bus(struct spi_slave *slave) /* standard 4-wire master mode: SCK, MOSI/out, MISO/in, nCS * REVISIT: this controller could support SPI_3WIRE mode. */ -#ifdef CONFIG_AM33XX +#ifdef CONFIG_OMAP3_SPI_D0_D1_SWAPPED /* - * The reference design on AM33xx has D0 and D1 wired up opposite - * of how it has been done on previous platforms. We assume that - * custom hardware will also follow this convention. + * Some boards have D0 wired as MOSI / D1 as MISO instead of + * The normal D0 as MISO / D1 as MOSI. */ - conf &= OMAP3_MCSPI_CHCONF_DPE0; - conf |= ~(OMAP3_MCSPI_CHCONF_IS|OMAP3_MCSPI_CHCONF_DPE1); + conf &= ~OMAP3_MCSPI_CHCONF_DPE0; + conf |= OMAP3_MCSPI_CHCONF_IS|OMAP3_MCSPI_CHCONF_DPE1; #else conf &= ~(OMAP3_MCSPI_CHCONF_IS|OMAP3_MCSPI_CHCONF_DPE1); conf |= OMAP3_MCSPI_CHCONF_DPE0;