net: zynq_gem: Dont run any phy detection logic for GMII case

This patch bypasses phy detection logic for GMII interface
and just depend on phy address received from DT. This patch
is required as phy detection logic is different for some phys
like xilinx phy which can be connected over SGMII and GMII
interface.
This fixes the issue of ethernet failures when xilinx phy is
connected over GMII interface.

Signed-off-by: Siva Durga Prasad Paladugu <sivadur@xilinx.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>

diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index 2cc49bca922a1f0896a9e6368813df77313b0661..1390c36c6141c610a47dfddd2e0e1164dad5888f 100644 (file)
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -325,7 +325,8 @@ static int zynq_phy_init(struct udevice *dev)
        /* Enable only MDIO bus */
        writel(ZYNQ_GEM_NWCTRL_MDEN_MASK, &regs->nwctrl);
 
-       if (priv->interface != PHY_INTERFACE_MODE_SGMII) {
+       if ((priv->interface != PHY_INTERFACE_MODE_SGMII) &&
+           (priv->interface != PHY_INTERFACE_MODE_GMII)) {
                ret = phy_detection(dev);
                if (ret) {
                        printf("GEM PHY init failed\n");