board: tqc: tqma6: hw init code disabled for device model

Keep code for non-dm configuration of baseboard WRU4.
It cannot be upgraded to device model as
we have no suitable device tree for it.
These changes were not run-tested on WRU4,
only compile-tested.

Signed-off-by: Michael Krummsdorf <michael.krummsdorf@ew.tq-group.com>

diff --git a/board/tqc/tqma6/tqma6.c b/board/tqc/tqma6/tqma6.c
index c8ddc2c1f8576c2cfb57440e84dd5ca29ad6a5c1..675341abdde37bc4c9249c5aa1442245c651f2a4 100644 (file)
--- a/board/tqc/tqma6/tqma6.c
+++ b/board/tqc/tqma6/tqma6.c
@@ -60,6 +60,7 @@ int dram_init(void)
 
 static const uint16_t tqma6_emmc_dsr = 0x0100;
 
+#ifndef CONFIG_DM_MMC
 /* eMMC on USDHCI3 always present */
 static iomux_v3_cfg_t const tqma6_usdhc3_pads[] = {
        NEW_PAD_CTRL(MX6_PAD_SD3_CLK__SD3_CLK,          USDHC_PAD_CTRL),
@@ -132,7 +133,9 @@ int board_mmc_init(bd_t *bis)
 
        return 0;
 }
+#endif
 
+#ifndef CONFIG_DM_SPI
 static iomux_v3_cfg_t const tqma6_ecspi1_pads[] = {
        /* SS1 */
        NEW_PAD_CTRL(MX6_PAD_EIM_D19__GPIO3_IO19, SPI_PAD_CTRL),
@@ -164,7 +167,9 @@ int board_spi_cs_gpio(unsigned bus, unsigned cs)
                (cs == CONFIG_SF_DEFAULT_CS)) ? TQMA6_SF_CS_GPIO : -1;
 }
 #endif
+#endif
 
+#ifdef CONFIG_SYS_I2C
 static struct i2c_pads_info tqma6_i2c3_pads = {
        /* I2C3: on board LM75, M24C64,  */
        .scl = {
@@ -194,6 +199,7 @@ static void tqma6_setup_i2c(void)
        if (ret)
                printf("setup I2C3 failed: %d\n", ret);
 }
+#endif
 
 int board_early_init_f(void)
 {
@@ -205,8 +211,12 @@ int board_init(void)
        /* address of boot parameters */
        gd->bd->bi_boot_params = PHYS_SDRAM + 0x100;
 
+#ifndef CONFIG_DM_SPI
        tqma6_iomuxc_spi();
+#endif
+#ifdef CONFIG_SYS_I2C
        tqma6_setup_i2c();
+#endif
 
        tqma6_bb_board_init();
 
@@ -235,6 +245,7 @@ static const char *tqma6_get_boardname(void)
        };
 }
 
+#ifdef CONFIG_POWER
 /* setup board specific PMIC */
 int power_init_board(void)
 {
@@ -251,6 +262,7 @@ int power_init_board(void)
 
        return 0;
 }
+#endif
 
 int board_late_init(void)
 {