mx6sabresd: Avoid calling setup_display() from SPL code

There is no need call setup_display() from SPL code, so move it to
board_init(), which executes only in U-Boot proper.

Reported-by: Stefano Babic <sbabic@denx.de>
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Reviewed-by: Stefano Babic <sbabic@denx.de>

diff --git a/board/freescale/mx6sabresd/mx6sabresd.c b/board/freescale/mx6sabresd/mx6sabresd.c
index 5b50bc815f4396a1e7270049fe6ae5abfe885845..f14b75927cabae9f2a61e674f3db0344ea0a8ecc 100644 (file)
--- a/board/freescale/mx6sabresd/mx6sabresd.c
+++ b/board/freescale/mx6sabresd/mx6sabresd.c
@@ -620,9 +620,6 @@ int board_ehci_power(int port, int on)
 int board_early_init_f(void)
 {
        setup_iomux_uart();
-#if defined(CONFIG_VIDEO_IPUV3)
-       setup_display();
-#endif
 
        return 0;
 }
@@ -639,6 +636,9 @@ int board_init(void)
                setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6q_i2c_pad_info1);
        else
                setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6dl_i2c_pad_info1);
+#if defined(CONFIG_VIDEO_IPUV3)
+       setup_display();
+#endif
 #ifdef CONFIG_USB_EHCI_MX6
        setup_usb();
 #endif