arm: mxs: Increase VDDD voltage to match specification

According to IMX28CEC rev. 4, 10/2018, Table 15. Recommended Operating
Conditions, page 16, the VDDD should be set to 1.55V when the CPU is
operating at 454MHz. This is the case in U-Boot, hence increase the
VDDD voltage. This fixes instability when performing TFTP transfers.
Increase the brownout threshold to 1.4V. The documentation recommends
1.45V setting for the brownout, however, this triggers failure during
power block init, so keep the brownout slightly lower.

Signed-off-by: Marek Vasut <marex@denx.de>
Cc: Stefano Babic <sbabic@denx.de>
Reviewed-by: Fabio Estevam <festevam@gmail.com>

diff --git a/arch/arm/cpu/arm926ejs/mxs/spl_power_init.c b/arch/arm/cpu/arm926ejs/mxs/spl_power_init.c
index a5c528a18da0d1711bbedb408a35f69829d2ef16..7a1b39844e3ef6fedbf2c04da73904185a74fde1 100644 (file)
--- a/arch/arm/cpu/arm926ejs/mxs/spl_power_init.c
+++ b/arch/arm/cpu/arm926ejs/mxs/spl_power_init.c
@@ -1254,8 +1254,8 @@ void mxs_power_init(void)
        debug("SPL: Setting VDDIO to 3V3 (brownout @ 3v15)\n");
        mxs_power_set_vddx(&mxs_vddio_cfg, 3300, 3150);
 
-       debug("SPL: Setting VDDD to 1V5 (brownout @ 1v315)\n");
-       mxs_power_set_vddx(&mxs_vddd_cfg, 1500, 1315);
+       debug("SPL: Setting VDDD to 1V55 (brownout @ 1v400)\n");
+       mxs_power_set_vddx(&mxs_vddd_cfg, 1550, 1400);
 #ifdef CONFIG_MX23
        debug("SPL: Setting mx23 VDDMEM to 2V5 (brownout @ 1v7)\n");
        mxs_power_set_vddx(&mxs_vddmem_cfg, 2500, 1700);