The name "se" is used in upstream Linux device trees and has been for
ages, long before this U-Boot-ism was introduced. Same goes for the
existing compatible. Get rid of that.
[vzapolskiy: removed a ready change in the driver]
Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org>
Signed-off-by: Vladimir Zapolskiy <vladimir.zapolskiy@linaro.org>
};
debug_uart: serial@a84000 {
- compatible = "qcom,msm-geni-uart";
+ compatible = "qcom,geni-debug-uart";
reg = <0xa84000 0x4000>;
reg-names = "se_phys";
- clock-names = "se-clk";
+ clock-names = "se";
clocks = <&gcc GCC_QUPV3_WRAP1_S1_CLK>;
pinctrl-names = "default";
pinctrl-0 = <&qup_uart9>;
Qualcomm GENI UART
Required properties:
-- compatible: must be "qcom,msm-geni-uart"
+- compatible: must be "qcom,geni-debug-uart"
- reg: start address and size of the registers
- clock: interface clock (must accept baudrate as a frequency)
}
static const struct udevice_id msm_serial_ids[] = {
- {.compatible = "qcom,msm-geni-uart"}, {}};
+ { .compatible = "qcom,geni-debug-uart" },
+ { }
+};
U_BOOT_DRIVER(serial_msm_geni) = {
.name = "serial_msm_geni",