net: zynq: Fix MDC setting for zynq

Based on spec:
"MDC must not exceed 2.5 MHz (MDC is only active during MDIO read and
write operations)"
Zynq is running on 111MHz. Current setting is 32 which is 111/32=3.47
which is above of 2.5MHz.
Using 48 divider will give us correct setting according spec
(111/48=2.31).

Signed-off-by: Michal Simek <michal.simek@xilinx.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>

diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index 4db3ed4339a9442f0d4da621860501f205f085f5..858093f0d7e236a417ebac4b8ad94a2be89cde30 100644 (file)
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -58,7 +58,7 @@
 #define ZYNQ_GEM_NWCFG_SPEED1000       0x000000400 /* 1Gbps operation */
 #define ZYNQ_GEM_NWCFG_FDEN            0x000000002 /* Full Duplex mode */
 #define ZYNQ_GEM_NWCFG_FSREM           0x000020000 /* FCS removal */
-#define ZYNQ_GEM_NWCFG_MDCCLKDIV       0x000080000 /* Div pclk by 32, 80MHz */
+#define ZYNQ_GEM_NWCFG_MDCCLKDIV       0x0000c0000 /* Div pclk by 48, max 120MHz */
 
 #ifdef CONFIG_ARM64
 # define ZYNQ_GEM_DBUS_WIDTH   (1 << 21) /* 64 bit bus */