net: mvneta: Remember fixed link instead of PHY address in priv data

We don't need to remember PHY address anymore, because since using DM
MDIO for connecting PHY, the address is parsed by mdio-uclass from
the ofnode.

But the driver uses a special value of the address to signal fixed link
usage.

Drop phyaddr add fixed_link in driver private structure. This simplifies
code a little.

Signed-off-by: Marek Behún <marek.behun@nic.cz>
Reviewed-by: Ramon Fried <rfried.dev@gmail.com>
Reviewed-by: Stefan Roese <sr@denx.de>

diff --git a/drivers/net/mvneta.c b/drivers/net/mvneta.c
index 24a491dcde67a726413d69a16c1685b224dab540..83e9629138fef72a7179309e2a58c0ef57a20529 100644 (file)
--- a/drivers/net/mvneta.c
+++ b/drivers/net/mvneta.c
@@ -277,12 +277,12 @@ struct mvneta_port {
        u16 rx_ring_size;
 
        phy_interface_t phy_interface;
+       bool fixed_link;
        unsigned int link;
        unsigned int duplex;
        unsigned int speed;
 
        int init;
-       int phyaddr;
        struct phy_device *phydev;
 #if CONFIG_IS_ENABLED(DM_GPIO)
        struct gpio_desc phy_reset_gpio;
@@ -576,13 +576,6 @@ static void mvneta_rxq_buf_size_set(struct mvneta_port *pp,
        mvreg_write(pp, MVNETA_RXQ_SIZE_REG(rxq->id), val);
 }
 
-static int mvneta_port_is_fixed_link(struct mvneta_port *pp)
-{
-       /* phy_addr is set to invalid value for fixed link */
-       return pp->phyaddr > PHY_MAX_ADDR;
-}
-
-
 /* Start the Ethernet port RX and TX activity */
 static void mvneta_port_up(struct mvneta_port *pp)
 {
@@ -834,7 +827,7 @@ static void mvneta_defaults_set(struct mvneta_port *pp)
        mvreg_write(pp, MVNETA_SDMA_CONFIG, val);
 
        /* Enable PHY polling in hardware if not in fixed-link mode */
-       if (!mvneta_port_is_fixed_link(pp)) {
+       if (!pp->fixed_link) {
                val = mvreg_read(pp, MVNETA_UNIT_CONTROL);
                val |= MVNETA_PHY_POLLING_ENABLE;
                mvreg_write(pp, MVNETA_UNIT_CONTROL, val);
@@ -1173,7 +1166,7 @@ static void mvneta_adjust_link(struct udevice *dev)
        struct phy_device *phydev = pp->phydev;
        int status_change = 0;
 
-       if (mvneta_port_is_fixed_link(pp)) {
+       if (pp->fixed_link) {
                debug("Using fixed link, skip link adjust\n");
                return;
        }
@@ -1548,7 +1541,7 @@ static int mvneta_start(struct udevice *dev)
        mvneta_port_power_up(pp, pp->phy_interface);
 
        if (!pp->init || pp->link == 0) {
-               if (mvneta_port_is_fixed_link(pp)) {
+               if (pp->fixed_link) {
                        u32 val;
 
                        pp->init = 1;
@@ -1698,7 +1691,6 @@ static int mvneta_probe(struct udevice *dev)
        void *blob = (void *)gd->fdt_blob;
        int node = dev_of_offset(dev);
        struct mii_dev *bus;
-       unsigned long addr;
        void *bd_space;
        int ret;
        int fl_node;
@@ -1742,14 +1734,9 @@ static int mvneta_probe(struct udevice *dev)
        fl_node = fdt_subnode_offset(blob, node, "fixed-link");
        if (fl_node != -FDT_ERR_NOTFOUND) {
                /* set phy_addr to invalid value for fixed link */
-               pp->phyaddr = PHY_MAX_ADDR + 1;
                pp->duplex = fdtdec_get_bool(blob, fl_node, "full-duplex");
                pp->speed = fdtdec_get_int(blob, fl_node, "speed", 0);
-       } else {
-               /* Now read phyaddr from DT */
-               addr = fdtdec_get_int(blob, node, "phy", 0);
-               addr = fdt_node_offset_by_phandle(blob, addr);
-               pp->phyaddr = fdtdec_get_int(blob, addr, "reg", 0);
+               pp->fixed_link = true;
        }
 
        bus = mdio_alloc();