sunxi: Pine64: temporarily remove extra Pine64 non-plus DT

With the merge of the new u-boot.itb size check now the build for
pine64_plus_defconfig breaks, as this file gets too large:
=============
u-boot.itb exceeds file size limit:
  limit:  516096 bytes
  actual: 521852 bytes
  excess: 5756 bytes
make: *** [u-boot.itb] Error 1
=============
One easily fixable reason is that we actually have two .dtbs in our FIT
image, one for the regular Pine64+ board, and one for the non-plus version.
The only difference U-Boot cares about is the 100Mbit Ethernet PHY used
on the non-plus version, however Ethernet isn't enabled in the non-plus
DT anyway.
So we could avoid the non-plus special handling, and remove that extra
.dtb from the FIT image, which saves a few KBs and brings us back below the
limit. The Pine64 would boot with a Pine64+ .dtb, and would fail to
enable Ethernet. Given that it didn't work in the first place, this is not
a regression.
Once we switch to a non-MMC environment, we can bring this back, then
with a proper .dtb and hopefully working Ethernet.

Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Signed-off-by: Maxime Ripard <maxime.ripard@bootlin.com>

diff --git a/configs/pine64_plus_defconfig b/configs/pine64_plus_defconfig
index 41ccff139d45a8358a9f6c8dadec42a94a155c4f..aef8c7d7a9efab926e48a7593ebdb206c5d4b995 100644 (file)
--- a/configs/pine64_plus_defconfig
+++ b/configs/pine64_plus_defconfig
@@ -10,7 +10,6 @@ CONFIG_SPL=y
 # CONFIG_SPL_DOS_PARTITION is not set
 # CONFIG_SPL_ISO_PARTITION is not set
 # CONFIG_SPL_EFI_PARTITION is not set
-CONFIG_OF_LIST="sun50i-a64-pine64 sun50i-a64-pine64-plus"
 CONFIG_SUN8I_EMAC=y
 CONFIG_USB_EHCI_HCD=y
 CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y