ARM: dts: sun4i: Sync from Linux v5.18-rc1

Copy the devicetree source for the A10 SoC and all existing boards
verbatim from the Linux v5.18-rc1 tag.

This commit also adds the following new board devicetree:
 - sun4i-a10-topwise-a721.dts

While this update should not impact any existing U-Boot functionality,
the changes to the USB PHY detection GPIO properties are needed to
convert that driver to use the DM GPIO framework.

Signed-off-by: Samuel Holland <samuel@sholland.org>

diff --git a/arch/arm/dts/sun4i-a10-inet97fv2.dts b/arch/arm/dts/sun4i-a10-inet97fv2.dts
index 5d096528e75a541e0ae1809a70b09139019da6c5..76016f2ca29daab81342102f32db82b33980a32d 100644 (file)
--- a/arch/arm/dts/sun4i-a10-inet97fv2.dts
+++ b/arch/arm/dts/sun4i-a10-inet97fv2.dts
@@ -1,7 +1,7 @@
 /*
  * Copyright 2014 Open Source Support GmbH
  *
- * David Lanzendörfer <david.lanzendoerfer@o2s.ch>
+ * David Lanzendörfer <david.lanzendoerfer@o2s.ch>
  *
  * This file is dual-licensed: you can use it either under the terms
  * of the GPL or the X11 license, at your option. Note that this dual
@@ -150,20 +150,6 @@
        status = "okay";
 };
 
-&pio {
-       usb0_id_detect_pin: usb0-id-detect-pin {
-               pins = "PH4";
-               function = "gpio_in";
-               bias-pull-up;
-       };
-
-       usb0_vbus_detect_pin: usb0-vbus-detect-pin {
-               pins = "PH5";
-               function = "gpio_in";
-               bias-pull-down;
-       };
-};
-
 &reg_dcdc2 {
        regulator-always-on;
        regulator-min-microvolt = <1000000>;
@@ -209,10 +195,8 @@
 };
 
 &usbphy {
-       pinctrl-names = "default";
-       pinctrl-0 = <&usb0_id_detect_pin>, <&usb0_vbus_detect_pin>;
-       usb0_id_det-gpio = <&pio 7 4 GPIO_ACTIVE_HIGH>; /* PH4 */
-       usb0_vbus_det-gpio = <&pio 7 5 GPIO_ACTIVE_HIGH>; /* PH5 */
+       usb0_id_det-gpios = <&pio 7 4 (GPIO_ACTIVE_HIGH | GPIO_PULL_UP)>; /* PH4 */
+       usb0_vbus_det-gpios = <&pio 7 5 (GPIO_ACTIVE_HIGH | GPIO_PULL_DOWN)>; /* PH5 */
        usb0_vbus-supply = <&reg_usb0_vbus>;
        usb2_vbus-supply = <&reg_usb2_vbus>;
        status = "okay";