imx: imx8mn_smm_s2: clean up board watchdog code

pinctrl_wdog already marked u-boot,dm-spl, so clean up board code.

The set_wdog_reset() function is not necessary as this is handled by
the imx_watchdog.c driver due to the 'fsl,ext-reset-output' property
being set.

Signed-off-by: Peng Fan <peng.fan@nxp.com>
Tested-by: Ariel D'Alessandro <ariel.dalessandro@collabora.com>

diff --git a/board/bsh/imx8mn_smm_s2/spl.c b/board/bsh/imx8mn_smm_s2/spl.c
index 0f61acc6302f5a83d23bad3bdc529a20459b8f96..4ccee7c31a8a03e123d7c061c3f368a6deea2680 100644 (file)
--- a/board/bsh/imx8mn_smm_s2/spl.c
+++ b/board/bsh/imx8mn_smm_s2/spl.c
@@ -40,19 +40,8 @@ void spl_board_init(void)
                puts("Failed to find clock node. Check device tree\n");
 }
 
-#define WDOG_PAD_CTRL  (PAD_CTL_DSE6 | PAD_CTL_ODE | PAD_CTL_PUE | PAD_CTL_PE)
-
-static const iomux_v3_cfg_t wdog_pads[] = {
-       IMX8MN_PAD_GPIO1_IO02__WDOG1_WDOG_B | MUX_PAD_CTRL(WDOG_PAD_CTRL),
-};
-
 int board_early_init_f(void)
 {
-       struct wdog_regs *wdog = (struct wdog_regs *)WDOG1_BASE_ADDR;
-
-       imx_iomux_v3_setup_multiple_pads(wdog_pads, ARRAY_SIZE(wdog_pads));
-       set_wdog_reset(wdog);
-
        init_uart_clk(3);
 
        if (IS_ENABLED(CONFIG_NAND_MXS)) {