arm64: zynqmp: Setup modeboot variable based on bootmode

Setup bootmode variable based on bootmode selection.
This is helping with setting up boot method.
Also setup sdbootdevice.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>

diff --git a/board/xilinx/zynqmp/zynqmp.c b/board/xilinx/zynqmp/zynqmp.c
index 8c859ed8ff8bdbf2dd17569b177aa16d125b09e5..7aa9628414febe3e037129c522188c7d3506c4aa 100644 (file)
--- a/board/xilinx/zynqmp/zynqmp.c
+++ b/board/xilinx/zynqmp/zynqmp.c
@@ -364,23 +364,28 @@ int board_late_init(void)
        case USB_MODE:
                puts("USB_MODE\n");
                mode = "usb";
+               env_set("modeboot", "usb_dfu_spl");
                break;
        case JTAG_MODE:
                puts("JTAG_MODE\n");
                mode = "pxe dhcp";
+               env_set("modeboot", "jtagboot");
                break;
        case QSPI_MODE_24BIT:
        case QSPI_MODE_32BIT:
                mode = "qspi0";
                puts("QSPI_MODE\n");
+               env_set("modeboot", "qspiboot");
                break;
        case EMMC_MODE:
                puts("EMMC_MODE\n");
                mode = "mmc0";
+               env_set("modeboot", "emmcboot");
                break;
        case SD_MODE:
                puts("SD_MODE\n");
                mode = "mmc0";
+               env_set("modeboot", "sdboot");
                break;
        case SD1_LSHFT_MODE:
                puts("LVL_SHFT_");
@@ -389,13 +394,16 @@ int board_late_init(void)
                puts("SD_MODE1\n");
 #if defined(CONFIG_ZYNQ_SDHCI0) && defined(CONFIG_ZYNQ_SDHCI1)
                mode = "mmc1";
+               env_set("sdbootdev", "1");
 #else
                mode = "mmc0";
 #endif
+               env_set("modeboot", "sdboot");
                break;
        case NAND_MODE:
                puts("NAND_MODE\n");
                mode = "nand0";
+               env_set("modeboot", "nandboot");
                break;
        default:
                mode = "";