From 12662e7034b4b6e070830e074f1cfab139dd21d6 Mon Sep 17 00:00:00 2001
From: Michal Simek <michal.simek@xilinx.com>
Date: Fri, 14 Jan 2022 13:25:36 +0100
Subject: [PATCH] firmware: zynqmp: Move loading message to debug
Power domain driver is using this function for every IP which is PD listed.
This can end up with a lot of messages which end up in boot log. That's why
show it only in EL3 as was used in past.
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
Link: https://lore.kernel.org/r/d73fc8bc663110b6e8d5e70fdb6435d1199e9db8.1642163135.git.michal.simek@xilinx.com
---
drivers/firmware/firmware-zynqmp.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/firmware/firmware-zynqmp.c b/drivers/firmware/firmware-zynqmp.c
index aa20e33b40..18a092c7b4 100644
--- a/drivers/firmware/firmware-zynqmp.c
+++ b/drivers/firmware/firmware-zynqmp.c
@@ -98,7 +98,8 @@ void zynqmp_pmufw_load_config_object(const void *cfg_obj, size_t size)
int err;
u32 ret_payload[PAYLOAD_ARG_CNT];
- printf("Loading new PMUFW cfg obj (%ld bytes)\n", size);
+ if (IS_ENABLED(CONFIG_SPL_BUILD))
+ printf("Loading new PMUFW cfg obj (%ld bytes)\n", size);
flush_dcache_range((ulong)cfg_obj, (ulong)(cfg_obj + size));
--
2.39.5