From bfeaea7d84f0c9d426a36968feadf17e3e344547 Mon Sep 17 00:00:00 2001
From: Igor Opaniuk <igor.opaniuk@toradex.com>
Date: Fri, 6 Dec 2019 18:24:16 +0200
Subject: [PATCH] colibri_imx6: fix broken fsl_esdhc_imx conversion
Not all CONFIG_FSL_ESDHC defines were properly replaced with
CONFIG_FSL_ESDHC_IMX, which broke U-boot proper booting on
Colibri iMX6 SoMs.
U-boot is stuck after this message:
Commercial temperature grade DDR3 timings, 64bit bus width.
Trying to boot from MMC1
Fixes: e37ac717d7("Convert to use fsl_esdhc_imx for i.MX platforms")
Signed-off-by: Igor Opaniuk <igor.opaniuk@toradex.com>
---
board/toradex/colibri_imx6/colibri_imx6.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/board/toradex/colibri_imx6/colibri_imx6.c b/board/toradex/colibri_imx6/colibri_imx6.c
index 10c595d584..a5cd8587da 100644
--- a/board/toradex/colibri_imx6/colibri_imx6.c
+++ b/board/toradex/colibri_imx6/colibri_imx6.c
@@ -83,7 +83,7 @@ iomux_v3_cfg_t const uart1_pads[] = {
MX6_PAD_CSI0_DAT11__UART1_TX_DATA | MUX_PAD_CTRL(UART_PAD_CTRL),
};
-#if defined(CONFIG_FSL_ESDHC) && defined(CONFIG_SPL_BUILD)
+#if defined(CONFIG_FSL_ESDHC_IMX) && defined(CONFIG_SPL_BUILD)
/* Colibri MMC */
iomux_v3_cfg_t const usdhc1_pads[] = {
MX6_PAD_SD1_CLK__SD1_CLK | MUX_PAD_CTRL(USDHC_PAD_CTRL),
@@ -304,7 +304,7 @@ int board_ehci_hcd_init(int port)
}
#endif
-#if defined(CONFIG_FSL_ESDHC) && defined(CONFIG_SPL_BUILD)
+#if defined(CONFIG_FSL_ESDHC_IMX) && defined(CONFIG_SPL_BUILD)
/* use the following sequence: eMMC, MMC */
struct fsl_esdhc_cfg usdhc_cfg[CONFIG_SYS_FSL_USDHC_NUM] = {
{USDHC3_BASE_ADDR},
--
2.39.5