From: Nils Le Roux Date: Sat, 2 Dec 2023 09:39:49 +0000 (+0100) Subject: net: designware: Support high memory nodes X-Git-Url: http://git.dujemihanovic.xyz/img/%7B%7B%20.RelPermalink%20%7D%7D?a=commitdiff_plain;h=a5f877a0bd64af97dbc812c9a0a8d7d6a353d943;p=u-boot.git net: designware: Support high memory nodes Some platforms (such as the Lichee Pi 4A) have their dwmac device addressable only in high memory space. Storing the node's base address on 32 bits is not possible in such case. Use platform's physical address type to store the base address. Signed-off-by: Nils Le Roux Cc: Andre Przywara Reviewed-by: Andre Przywara --- diff --git a/drivers/net/designware.c b/drivers/net/designware.c index c15fb36ae3..c222197b11 100644 --- a/drivers/net/designware.c +++ b/drivers/net/designware.c @@ -685,8 +685,8 @@ int designware_eth_probe(struct udevice *dev) { struct eth_pdata *pdata = dev_get_plat(dev); struct dw_eth_dev *priv = dev_get_priv(dev); - u32 iobase = pdata->iobase; - ulong ioaddr; + phys_addr_t iobase = pdata->iobase; + void *ioaddr; int ret, err; struct reset_ctl_bulk reset_bulk; #ifdef CONFIG_CLK @@ -746,16 +746,18 @@ int designware_eth_probe(struct udevice *dev) * or via a PCI bridge, fill in plat before we probe the hardware. */ if (IS_ENABLED(CONFIG_PCI) && device_is_on_pci_bus(dev)) { - dm_pci_read_config32(dev, PCI_BASE_ADDRESS_0, &iobase); - iobase &= PCI_BASE_ADDRESS_MEM_MASK; - iobase = dm_pci_mem_to_phys(dev, iobase); + u32 pcibase; + dm_pci_read_config32(dev, PCI_BASE_ADDRESS_0, &pcibase); + pcibase &= PCI_BASE_ADDRESS_MEM_MASK; + + iobase = dm_pci_mem_to_phys(dev, pcibase); pdata->iobase = iobase; pdata->phy_interface = PHY_INTERFACE_MODE_RMII; } - debug("%s, iobase=%x, priv=%p\n", __func__, iobase, priv); - ioaddr = iobase; + debug("%s, iobase=%pa, priv=%p\n", __func__, &iobase, priv); + ioaddr = phys_to_virt(iobase); priv->mac_regs_p = (struct eth_mac_regs *)ioaddr; priv->dma_regs_p = (struct eth_dma_regs *)(ioaddr + DW_DMA_BASE_OFFSET); priv->interface = pdata->phy_interface;