From: Michael Walle Date: Wed, 17 Aug 2022 19:38:09 +0000 (+0200) Subject: board: lsxl: update the README X-Git-Url: http://git.dujemihanovic.xyz/img/%7B%7B%20%28.OutputFormats.Get?a=commitdiff_plain;h=560a5c3bb3bedac7d1da93362401a1d926214660;p=u-boot.git board: lsxl: update the README Update the board's README to reflect all the recent changes. Signed-off-by: Michael Walle Reviewed-by: Stefan Roese --- diff --git a/board/buffalo/lsxl/README b/board/buffalo/lsxl/README index fffb1ce8ec..dd9e943380 100644 --- a/board/buffalo/lsxl/README +++ b/board/buffalo/lsxl/README @@ -31,8 +31,8 @@ generated if no valid address could be loaded from the environment variable 'ethaddr' and a DHCP request is sent. After a successful DHCP response is received, the network settings are configured and the ncip is unset. Thus all netconsole packets are broadcasted and you can use the netconsole to -access board from any host within the network segment. To determine the IP -address assigned to the board, you either have to sniff the traffic or +access the board from any host within the network segment. To determine the +IP address assigned to the board, you either have to sniff the traffic or check the logs/leases of your DHCP server. The resuce mode is selected by holding the push button for at least one @@ -42,41 +42,43 @@ the resuce mode is enabled, thus providing a visual feedback. Pressing the same button for at least 10 seconds on power-up will erase the environment and reset the board. In this case the visual indication will be: -- blinking blue, for about one second -- solid amber, for about nine seconds -- blinking amber, until you release the button +- blue, for about one second +- amber, for about nine seconds +- red, until you release the button This ensures, that you still can recover a device with a broken environment by first erasing the environment and then entering the rescue mode. Once the rescue mode is started, use the ncb binary from the tools/ -directory to access your board. There is a helper script named -'restore_env' to save your changes. It unsets all the network variables -which were set by the rescue mode, saves your changes and then resets the -board. +directory to access your board. The common use case for this is setting a MAC address. Let us assume you -have an empty environment, the board comes up with the amber LED blinking. +have an empty environment, the board comes up with the amber LED turned on. Then you enter the rescue mode, connect to the board with the ncb tool and use the following commands to set your MAC address: - setenv ethaddr 00:00:00:00:00:00 - run restore_env + setenv -f ethaddr 00:00:00:00:00:00 + saveenv + reset Of course you need to replace the 00:00:00:00:00:00 with your valid MAC address, which can be found on a sticker on the bottom of your box. +You cannot store the network console setting in the environment. On reset +it is automatically restored to serial. Therefore, you have to use the +push-button to enter resuce mode again. + Status LED ---------- -blinking blue +blue Bootloader is running normally. -blinking amber +amber No ethaddr set. Use the `Rescue Mode` to set one. -blinking red +red Something bad happend during loading the operating system. The default behavior of the linux kernel is to turn on the blue LED. So if