From: Kory Maincent Date: Wed, 29 May 2024 10:01:06 +0000 (+0200) Subject: xilinx: zynqmp: Allow multiboot environment write even in saved environment X-Git-Url: http://git.dujemihanovic.xyz/html/static/gitweb.css?a=commitdiff_plain;h=86c46b99a0e96a7281c153ca78c8e8890967997f;p=u-boot.git xilinx: zynqmp: Allow multiboot environment write even in saved environment Once the environment was saved, the current multiboot image information became unreachable. When dealing with firmware updates, this information is necessary alongside the saved environment to know the booted image. Move the multiboot environment set operation before the saved environment check to ensure this information is always available. Signed-off-by: Kory Maincent Link: https://lore.kernel.org/r/20240529100107.137159-1-kory.maincent@bootlin.com Signed-off-by: Michal Simek --- diff --git a/board/xilinx/zynqmp/zynqmp.c b/board/xilinx/zynqmp/zynqmp.c index c4050af2a5..63cc6b862e 100644 --- a/board/xilinx/zynqmp/zynqmp.c +++ b/board/xilinx/zynqmp/zynqmp.c @@ -519,6 +519,10 @@ int board_late_init(void) usb_ether_init(); #endif + multiboot = multi_boot(); + if (multiboot >= 0) + env_set_hex("multiboot", multiboot); + if (!(gd->flags & GD_FLG_ENV_DEFAULT)) { debug("Saved variables - Skipping\n"); return 0; @@ -531,10 +535,6 @@ int board_late_init(void) if (ret) return ret; - multiboot = multi_boot(); - if (multiboot >= 0) - env_set_hex("multiboot", multiboot); - if (IS_ENABLED(CONFIG_DISTRO_DEFAULTS)) { ret = boot_targets_setup(); if (ret)