From: John Keeping Date: Tue, 17 Jan 2023 17:07:47 +0000 (+0000) Subject: mmc: rockchip_dw_mmc: fix DDR52 8-bit mode handling X-Git-Url: http://git.dujemihanovic.xyz/html/static/git-logo.png?a=commitdiff_plain;h=ea0f7662531fd360abf300691c85ceff5a0d0397;p=u-boot.git mmc: rockchip_dw_mmc: fix DDR52 8-bit mode handling The RK3288 TRM states that, for 8-bit DDR modes: The CLKDIV register should always be programmed with a value higher than zero (0); that is, a clock divider should always be used for 8-bit DDR mode. In Linux, the driver applies this logic for all SoCs using the driver and does not distinguish RK3288, so presumably this requirement is the same for all other Rockchip SoCs using this IP. Add the necessary code to double the clock frequency when 8-bit DDR is selected. The dw_mmc core already handles setting CLKDIV correctly given the input clock and desired bus clock. Signed-off-by: John Keeping Reviewed-by: Jaehoon Chung --- diff --git a/drivers/mmc/rockchip_dw_mmc.c b/drivers/mmc/rockchip_dw_mmc.c index 573bf16c87..3661ce3314 100644 --- a/drivers/mmc/rockchip_dw_mmc.c +++ b/drivers/mmc/rockchip_dw_mmc.c @@ -41,6 +41,14 @@ static uint rockchip_dwmmc_get_mmc_clk(struct dwmci_host *host, uint freq) struct rockchip_dwmmc_priv *priv = dev_get_priv(dev); int ret; + /* + * The clock frequency chosen here affects CLKDIV in the dw_mmc core. + * That can be either 0 or 1, but it must be set to 1 for eMMC DDR52 + * 8-bit mode. It will be set to 0 for all other modes. + */ + if (host->mmc->selected_mode == MMC_DDR_52 && host->mmc->bus_width == 8) + freq *= 2; + ret = clk_set_rate(&priv->clk, freq); if (ret < 0) { debug("%s: err=%d\n", __func__, ret);