From: Masahisa Kojima Date: Wed, 24 May 2023 07:32:46 +0000 (+0900) Subject: spi: synquacer: remove SPI_TX_BYTE handling X-Git-Url: http://git.dujemihanovic.xyz/html/static/git-logo.png?a=commitdiff_plain;h=1d70101aa2a489529847231c741dff4f235cfeaa;p=u-boot.git spi: synquacer: remove SPI_TX_BYTE handling Current code expects that SPI_TX_BYTE is single bit mode but it is wrong. It indicates byte program mode, not single bit mode. If SPI_TX_DUAL, SPI_TX_QUAD and SPI_TX_OCTAL bits are not set, the default transfer bus width is single bit. Signed-off-by: Masahisa Kojima Reviewed-by: Ilias Apalodimas Reviewed-by: Jagan Teki --- diff --git a/drivers/spi/spi-synquacer.c b/drivers/spi/spi-synquacer.c index 0f5d0a30c3..553f9687e3 100644 --- a/drivers/spi/spi-synquacer.c +++ b/drivers/spi/spi-synquacer.c @@ -186,7 +186,7 @@ static void synquacer_spi_config(struct udevice *dev, void *rx, const void *tx) struct udevice *bus = dev->parent; struct synquacer_spi_priv *priv = dev_get_priv(bus); struct dm_spi_slave_plat *slave_plat = dev_get_parent_plat(dev); - u32 val, div, bus_width = 1; + u32 val, div, bus_width; int rwflag; rwflag = (rx ? 1 : 0) | (tx ? 2 : 0); @@ -203,16 +203,14 @@ static void synquacer_spi_config(struct udevice *dev, void *rx, const void *tx) priv->mode = slave_plat->mode; priv->speed = slave_plat->max_hz; - if (priv->mode & SPI_TX_BYTE) - bus_width = 1; - else if (priv->mode & SPI_TX_DUAL) + if (priv->mode & SPI_TX_DUAL) bus_width = 2; else if (priv->mode & SPI_TX_QUAD) bus_width = 4; else if (priv->mode & SPI_TX_OCTAL) bus_width = 8; else - log_warning("SPI mode not configured, setting to byte mode\n"); + bus_width = 1; /* default is single bit mode */ div = DIV_ROUND_UP(125000000, priv->speed);